Truch stalls on slow speed turn and at lights not all the time but when it does I have rough idle dealer can't figure it out. Engine code p3003 multiple cyclynder misfire. If you pull battery cable off and reset the computer runs fine until something triggers the condition. Replaced erg valve plug wires cam sensor cleaned injectors verified fuel pressure all good clean throttle body
SOURCE: 1997 dodge dakota v6 engine wont start replaced
turn the key to the on position a see if you can here a buzzing sound around the fuel tank,if you don't hear a sound then. (be very careful while doing this) with the key off take a fuel line coming from the tank loose,make sure its pointed away from you and turn the key to the on position,see if any gas comes out,if not then your fuel pump is probably bad.
SOURCE: 1999 Pontiac Firebird multiple misfire
It could be a clogged fuel filter, bad gas. Or if you have done alot of modifications to it, the injectors may not be able to keep up.
SOURCE: 96 Dodge Intrepid ES, engine stalls
Find your firewall electrical junction block (where all the wires enter the cabin on the passenger side) and with a zip tie pull up the wire bundle so it does not ride on the upper tie rods and, fasten the zip tie to anything that is solid in the engine compartment and, let me know what happens
SOURCE: check engine light goes off and on, test shows
change the plugs and wires.. in need of a tune up..
SOURCE: random/multiple cylinder misfire
if you have done the basics of replacing plugs and wires,
what I found on a dodge that was doing the same thing,
I could watch the misfires happening on the scanner but the engine wasn't missing,turned out to be dirt and things floating in the fuel rail and partially plugging the screens on the injectors.
Testimonial: "Thank you,"
129 views
Usually answered in minutes!
×