I need to remove the bumper on a mazda 2005 mpv so I can try and knock out a small dent. thanks fred
Removal of the rear bumper on an Mazda 2004 to 2006 MPV.
It's afairly simple task: 1) Open the rear hatch or (door) remove the torx screws at the bottom of the weather strip. 2) Remove both tail lights by unscrewing the two phillip screws on each light, once removed the lights pulling toward the side of the van. Let them hang from the wires. You will see a clip (white in color),pry it out from behind the bumper material and go to the next step. 3) Remove three 8mm head screws in each fender well and three plastic clips. Then remove an 8mm screw at the top corner of the bumper against the rear fender. If your car has splash guards remove them as well. 4) Remove the two clips at the bottom of the bumper attached to the under carriage. 5) Pull the bumper toward the back of the vehicle be careful with the tail lights. Remember, they are hanging loose.
And that's it, you have done it.
Ferni
SOURCE: dented right rear bumper
If it isn't hurt too bad, put a heat light or heat gun to it for a few minutes, it might pop back out or if you can get up behind the damage, work it out with your hand while it is warm, wear gloves in case you get it too warm. About $650.00 painted and installed.
SOURCE: water pump replacement in a 2002 Mazda MPV
The reason is the water pump is driven off the timing belt, extra parts and allot more labor. No the eng does not have to be removed, labor time around 4 hours, parts about, about $125 US for parts, if it is a dealer add $75 US
SOURCE: i need to change the 3 rear sparkplugs on my mazda mpv v6 engine?
Remove the intake manifold. Book time is about 2.5 hours. No very difficult if you pay attension.
SOURCE: 2004 toyota rav4 rear bumper assembly guide
there are two bolts to the center and two around the corner on at the edge up high and one at the bottom of the bumper/ Please rate my response thank you very much
SOURCE: how do I remove the back bumper (plastic) on a 2003 toyota camry?
you can heat the bumper heat gun ( you can rent one i think?)
this will soft the bumper so you push it out easily on the car
1. inside your trunk remove small back clips in trim panel
2. remove tail lamp four 8mm nut perside unplug wires
3. remove black clips under tail lamps ( flat head screwdriver to pull center of the clip up slowly then remove the hole clip)
4. three if the some clips are bottom if the bumper
5. three or four 10mm nuts in side the quarter panel on the right and left side
6.four s shape clips are top bumper that will pull loose
7. with some help slide bumper by pulling it off it
8. when you reinstall the bumper you may need to tape the strophe reinforcement in place
1,123 views
Usually answered in minutes!
×