When i turn the lights on to see at night my tail light stay off but when I press the brakes the tail light turn on then turn of when i let go of the brakes
SOURCE: Tail lights wont work
sounds like ground problem- remove tail lights and look for wires going to body -remove screww clean grounding area and replace- both sides. You did not say whether the lights work when car is off? With car off and brake pedal pushed is there any brake lights ? If not procede with above.
SOURCE: Tail lights work, but not one brake light when braking at night.
2001 jeep grand cherokee left brake does not work period. I replaced bulb to no avail. the entire tail lamp assembly looked brown as though it heated up. However, the tail light, signal light and back-up lights still work. Please help.
Mike.
SOURCE: Right brake light out; tail light works fine
most rear tail lights and turn/stop lights are the same dual filiment bulb. it is possible for your tail light to work and your brake light not to and still have a bad bulb. I would check the bulb first, your brake light works on the left yes? this would mean that the fuse is fine
SOURCE: Right tail light not working when pressing brake w/ lights on.
There should be at least 2 bulbs in the light assembly. One light is the light that is on when you turn on your headlights with out the brake pressed, the other light only lights up while you press on the brake. Make sure you are replacing the correct bulb. You may have been replacing the bulb that stays on. Your lights may be set up to turn off the light that stays on when the headlights are on while pressing the brakes.
SOURCE: Tail Lights & Brake Lights stay on even when car is turn off
you need a brake light stop switch. it is located on the brake pedal at the top. really easy to change out.
1,577 views
Usually answered in minutes!
×