Rear winshield wipers won't work

see the diagram attached and fix it. God bless you

have you checked the fuse and relay.

I know this question is old, but I am responding so others with the same problem can see. I wired the Rear Window Motor Park Signal wire and the Rear Window Motor Speed Signal wire together and it completely bypassed the rear wiper motor. Now the window goes up and down. This doesn't fix the rear wiper motor, but you will be able to have access to it now that the window is out of the way

I made and album to show.

http://imgur.com/a/q3vww

Hey Paul, there are limit switches integrated into the motor on your sunroof, usually if it stops completely its because it detected a restriction, such as leaves, or dirt, if there are no visual sign then with the key on hold the switch to the full open position for 10-12 sec then hold it in the close position for the same, cycle the key and see if it reset. The motor can fail as well but it's not very common.. Do u hear any clicking from the motor area when this occurs, also check all fuses to be safe as well,..

In order to find out what's causing the problem, the headliner must be dropped (removed) to access the sunroof motor so it can be inspected and removed to inspect the slide cables up inside the sunroof/moonroof assy. Until that's done, there's not much more I can do to help except speculate.

It could definately be the wiper relay, and it could also be the wiper motor. If you put a long screw driver on the relay and have someone turn the wipers on with the key on, you should be able to hear the relay clicking as it opens and closes. Sometimes you can put your finger on the relay and feel the relay switching. If you can hear/feel the relay then the next step is the wiper motor. Hope this helps.

Sounds like the windshield wiper motor needs to be replaced. The gear inside may be stripped so you'll hear it running but it won't do anything. I've had that happen with the rear wiper motor. Hope that helps.

Remove wiper arms,open hood and remove plastic cowl(cover) at windshield,it is held in with plastic clips,the wiper motor is under the cover held in with 4 bolts(10mm).reinstall everything and turn on motor without wiper arms ,then turn it off so it finds its off position-reinstall wiper arms

Sorry I cant offer any soloution but I do have the Same Problem :( I know its a long time ago but did you find the answer to fix the problem? Would love to Know :)

Kind regards
Ian