Washer does not work
SOURCE: windshield washer pump wont work
The inside fuse panel is located on the passenger side center console. The other fuse block is located under the hood on the drivers side.
SOURCE: My 2005 Jeep Grand Cherokee's windshield washer is not working.
Check power at the pump motors. You may not see a fuse because some run off a circuit breaker. If all else fails, a bit "backyard" but you likely could break out the washer pumps from the system and make a simple push button on the dash to operate them.
SOURCE: Winshield washer motor does not run
These days, most windshield washer pumps are mounted to the bottom of the washer fluid reservoir. Where’s that, you ask? Well, you know that spout you pour the fluid into—the one that disappears into nowhere? Well, the reservoir is actually located inside the front fender between the bumper and the front wheel. To replace the pump, you will have to jack up the vehicle, remove the front wheel and then remove the inner fender liner.
SOURCE: where is the fuse located for the windshield washer motor
Hello and Welcome to Fixya
The fuse is in the engine compartment fuse box. See diagram in the owners manual section 6-11..to find out which one it is, or read the list (provided with amp labeling) on the inside cover to review the fuses there.
Locate the windshield washer fuse accordingly and replace it with the same labeled new fuse.
Do RATE my solution, If this helps you out.
Regards.
Testimonial: "thanks"
SOURCE: Which fuse runs the windshield washer pump on 98 Toyota Corolla?
it could be powered thru a relay
7,098 views
Usually answered in minutes!
×