Serpintine belt diagram 1998 ford escort zx2 sport

The picture is for a zetec. Let me know if wrong diagram?

email me at [email protected] and I can get a diagram to you so you know exactly what you are looking for under the hood.

Here it is. 13mm wrench to rotate tensioner

If there is no diagram on the underside of your hood, or around the engine compartment, just wrap it around the crankshaft, and work your way around the pulleys, going flats to flats, ribs to ribs. There may be a couple of combinations, but you'll get it.

If you have A/C look here:




Without AC:

Here's a link to the serpentine belt diagram...
http://www.gates.com/common/part_locator/view_diagram.cfm?id=S8007

This information can be found at www.serpentinebeltdiagram.com
They have all the belt routing info for any vehicle with a serpentine belt.
Hope this helps....

go to gates.com and click the link on the left that says Part Locator & Interchange, put in your car info then look down the page and click the camera next to the serpintine belt. These belts are not usually hard to change, the tensioner pulley should have a 3/8" square drive hole in it to release the tension, I always start at the crankshaft and loop around leaving the tensioner for last, hope this helps, let me know

Try this link.

http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c152801e9826

Call a Ford parts dept and ask them if you can get a routing diagram they can fax or pick it up thats the best way label take weeks to get in so do that and keep the copy in your car file Please rate my response thank you very much