I was wanting to know how to find the location of the chime on the car and how to find out where I could find a new chime if needed. I have been trying to find the part # for this so that I could see a picture. So, I could look under the dash I might be able to identify it. Thanks, Don
No other warning chimes work or just the headlamps ?
Warning Devices
The warning device system consists of the following components:
Visual Inspection Chart
Mechanical
Electrical
Smart Junction Box (SJB) Diagnostic Trouble Code (DTC) Index
DTC
Description
Source
Action
B1342
SJB is Defective
SJB
INSTALL a new SJB. REFER to Section 419-10 .
B1352
Ignition Key-In Circuit Failure
SJB
Go To Pinpoint Test B .
B1577
Lamp Park Input Circuit Short to Battery
SJB
Go To Pinpoint Test E .
C1167
Park Brake Actuator Assembly Switch Released Circuit Short to Ground
SOURCE: blown headlight drivers side 2005 ford taurus
There are no screws need to be removed from the headlight bezel as the lamp need be only removed from the rear. On the rear of the headlight unplug the wiring harness, then turn the big hand screw /catch only 1/4 turn and pull out the socket and lamp straight out. then replace the burnt lamp and do the reverse of which you did to get it out.
SOURCE: 1997 Ford Taurus flasher location/replacement
images from a 97 Ford Taurus, GL body type. Shows location of flasher and a simple removal tecnique I discovered. The alternative was insane contortion.
SOURCE: My dash lights are out and headlights. Is there a
Yes there will be a fuse box either under the hood, very large square and black, if its not there its under the dash, the fuse you are looking for is your running light fuse
SOURCE: 2005 Tahoe Z71 short bleep noise from driver side
try turning off heater controls before switching off key, to see if noise changes or stops
SOURCE: Where is pcv valve located on 2005 taurus
It is below the egr valve close to the intake manifold below the intake air sensor, there is a tube running to it from the engine to recirculate exhaust air with fresh air, there is a clamp holding it to the air intake that you need pliers to remove, then you need to turn counter-clockwise 90 degrees to remove, do the reverse to install. to make it easier to access remove the upper intake. The pcv valve is not visible, however, you can identify it by the 3" inch long rubber hose that connects to the steel line running into the bottom of the intake. I have the part and am going to replace it soon, although Ford really makes it difficult to remove it -
pcv valve is located just under the throttle body. remove air cleaner assembly from throttle body and you will see a u shaped hose running horizontally.
456 views
Usually answered in minutes!
×