SOURCE: Interior Door Handle
This was a three minute repair, once I had the replacement handle. Leave the door panel alone! Remove the single screw holding the old handle in place. Use a flat blade screwdriver to jimmy the old handle away from the door about an inch. There are two plastic clips holding it to the rods, one for the locking mechanism and one for the latch. Use the flat blade screwdriver to unclip these two connectors. Remove the broken latch, and don't worry, the rods won't disappear into the door! Reverse these steps with the new handle (insert rods, attach clips, wiggle assembly into place, and fasten with single screw). You're done!
SOURCE: how do you get the inside dr panel of a hyundai accent e 1998 1.3
Probably hard to see, or you'd have seen it. But there should be a clip just behind the center of the window crank. If you puch the door panel back away from the winder, you can take a curved pick and slide it out one way. It is open on one end, so you must slide it away from this opening. It sort of looks like a clip shaped like an open fish mouth. Need a tiny pick to hook it and pull it out sideways. Good luck. TT
SOURCE: how do i remove the interior door handle on 2000
how do i set the mileage back on a 2008 hyundai accent, had to change dash
SOURCE: Need to remove inside door skin on 2002 Hyundai
there is a plastic c-clip that holds the window handle on. you can use a screwdriver topry it off or a rag works well if you can get it stuck in the clip.
SOURCE: Interior dasboard lights do not work
try changing the bulbs, all u need is a phillips screw driver to remove the speedometer console..
116 views
Usually answered in minutes!
×