Check this TSB...
Set Condition: This code is set if the voltage detected on the 3-4 Shift Solenoid Control
Circuit at the PCM is difference than the expected voltage.
POSSIBLE CAUSES
FUSED B(+) FEED TO TRANS CONTROL RELAY OPEN
TRANS CONTROL RELAY
3-4 SOLENOID CONTROL CIRCUIT OPEN
3-4 SOLENOID WIRING HARNESS INTERMITTENT
3-4 SOLENOID WIRING HARNESS
SHIFT SOLENOID CONTROL CIRCUIT SHORT TO GROUND
SOLENOID AND HARNESS (SOLENOID CONTROL CKT)
SOLENOID AND HARNESS (SOLENOID PACK CONN)
TRANS RELAY OUTPUT CIRCUIT OPEN
TRANS RELAY OUTPUT CIRCUIT SHORTED TO GROUND
PCM (3-4 SOL CONTROL CKT)
PCM (CODE SET)
POWERTRAIN CONTROL MODULE
TEST ACTION APPLICABILITY
1 Key On.
With the DRB, read trouble codes.
Is the Trans 12 volt Supply Relay Control Circuit code set?
All
Yes - Refer to symptom P-1765 TRANS 12 VOLT SUPPLY RELAY CONTROL CIRCUIT in the TRANSMISSION category.
No - Go To 2
2 Key On.
With the DRB, read trouble codes.
Is the DTC Specific Good Trip displayed and equal to zero?
All
Yes - Go To 3
No - Go To 17
555 TRANSMISSION
TEST ACTION APPLICABILITY
3 The code is present at this time.
Key On.
Check and record Freeze Frame data to determine the conditions when the code was set before disconnecting the PCM Connectors.
Note: Freeze Frame data will be erased.
Road test Vehicle. Attain Vehicle speed of at least 50 MPH.
Push OD Switch 4 times such that Vehicle attempts to shift from 3rd to 4th and back.
Did the Vehicle shift between 3rd and 4th?
All
Yes - Go To 17
No - Go To 4
4 Key Off.
Disconnect the Trans Solenoid Pack Connector.
Note: Check connectors - Clean/repair as necessary.
Turn Key On.
With the DRB, actuate Trans Control Relay.
Using a Voltmeter, measure the voltage at the Trans Relay Output Circuit.
Does the voltage fluctuate from 0.0 volt to over 10.0 volts?
All
Yes - Go To 5
No - Go To 13
5 Key Off.
Disconnect the Trans Solenoid Pack Connector.
Disconnect the Powertrain Control Module White Connector.
Note: Check connectors - Clean/repair as necessary.
Key On.
Using a voltmeter, measure the voltage at the 3-4 Shift Solenoid Control Circuit.
Is the voltage above 10.0 volts?
All
Yes - Go To 6
No - Go To 7
6 Key Off.
Repair 3-4 Solenoid Control Circuit shorted to voltage.
Reconnect all disconnected Connectors.
Road test Vehicle. Attain Vehicle speed of at least 50 MPH.
Push OD Switch 4 times such that Vehicle attempts to shift from 4th to 3rd and back.
Did the Vehicle shift between 3rd and 4th?
All
Yes - Test Complete.
Perform Powertrain Verification Test VER-5A.
No - Replace the PCM.Perform Powertrain Verification Test VER-5A.
7 Key Off.
Disconnect the Powertrain Control Module White Connector.
Note: Check connectors - Clean/repair as necessary.
Using a Ohmmeter, measure the resistance between the 3-4 Shift Solenoid Control
Circuit at the PCM Connector and Ground (B-).
Is the resistance below 5.0 ohms?
All
Yes - Go To 8
No - Go To 9
556 TRANSMISSION
TEST ACTION APPLICABILITY
8 Key Off.
Disconnect the Trans Solenoid Pack Connector.
Disconnect the Powertrain Control Module White Connector.
Note: Check connectors - Clean/repair as necessary.
Using an Ohmmeter, measure the resistance between the 3-4 Shift Solenoid Control
Circuit at the PCM Connector and Ground.
Is the resistance below 5.0 ohms?
All
Yes - Repair the 3-4 Shift Solenoid Control Circuit shorted to ground.
Perform Powertrain Verification Test VER-5A.
No - Replace the Solenoid and Harness Assembly.
Perform Powertrain Verification Test VER-5A
9 Key Off.
Disconnect the Powertrain Control Module White Connector.
Remove the Trans Control Relay.
Note: Check connectors - Clean/repair as necessary.
Using an Ohmmeter measure between the Trans Control Relay Output Circuit at the
Relay and the 3-4 Solenoid Control Circuit at the PCM Connector.
Is the resistance above 40.0 ohms?
All
Yes - Go To 10
No - Go To 12
10 Key Off.
Disconnect the Powertrain Control Module White Connector.
Disconnect the Trans Solenoid Pack Connector.
Note: Check connectors - Clean/repair as necessary.
Using an Ohmmeter, measure the 3-4 Solenoid Control Circuit from the PCM
Connector to the Solenoid Connector.
Is the resistance below 5.0 ohms?
All
Yes - Go To 11
No - Repair the open 3-4 Solenoid Control Circuit.
Perform Powertrain Verification Test VER-5A.
11 If there are no potential causes remaining.
View repair options.
All
Repair
Replace the Solenoid and Harness Assembly.
Perform Powertrain Verification Test VER-5A.
12 Key Off.
Disconnect the Powertrain Control Module White Connector.
Remove the Trans Control Relay.
Note: Check connectors - Clean/repair as necessary.
Using a Ohmmeter measure between the Trans Control Relay Output Circuit at the
Relay and the 3-4 Solenoid Control Circuit at the PCM Connector.
Is the resistance between 26.0 and 40.0 ohms?
All
Yes - Replace the PCM.
Perform Powertrain Verification Test VER-5A.
No - Replace the Solenoid and Harness Assembly.
Perform Powertrain Verification Test VER-5A
557 TRANSMISSION
TEST ACTION APPLICABILITY
13 Key Off.
Remove the Trans Control Relay.
Note: Check connectors - Clean/repair as necessary.
Key On.
Using a Voltmeter, measure the Fused B(+) Circuit in the Relay Connector.
Is voltage above 10.0 volts?
All
Yes - Go To 14
No - Repair the open Fused B(+) Feed to the Trans Control Relay.
Perform Powertrain Verification Test VER-5A.
14 Key Off.
Disconnect the Trans Solenoid Pack Connector.
Remove the Trans Control Relay.
Note: Check connectors - Clean/repair as necessary.
Using a Ohmmeter, measure the Trans Control Relay Output Circuit from the Relay
Connector to the Solenoid Connector.
Is the resistance above 5.0 ohms?
All
Yes - Repair the open Trans Relay Output Circuit.
Perform Powertrain Verification Test VER-5A.
No - Go To 15
15 Key Off.
Disconnect the Trans Solenoid Pack Connector.
Remove the Trans Control Relay.
Note: Check connectors - Clean/repair as necessary.
Using a Ohmmeter, measure between the Trans Control Relay Output Circuit and Ground.
Is the resistance below 5.0 ohms?
All
Yes - Repair the Trans Relay Output Circuit shorted to ground.
Perform Powertrain Verification Test VER-5A.
No - Go To 16
16 If there are no potential causes remaining.
View repair options.
All
Repair
Replace the Trans Control Relay.
Perform Powertrain Verification Test VER-5A.
17 Key On.
Check and record freeze frame data to determine the conditions when the code was set.
Erase the DTC.
Warning: This will erase the Freeze Frame data.
Attempt duplication of Freeze Frame Data to help reset the code.
Key Off.
Using the Schematic as a guide, inspect the Wiring and Connectors.
Were any problems found?
All
Yes Repair as necessary.
Perform Powertrain Verification Test VER-5A.
No Go To 18
558 TRANSMISSION
TEST ACTION APPLICABILITY
18 Key On.
Note: Actuate the 3-4 Solenoid or the test can be done with the Engine running.
Wiggle the Wiring Harness from the Solenoid to the PCM.
Note: You are attempting to set the code.
With the DRB, read DTC's.
Does the 3-4 Solenoid Control Circuit Trouble Code appear?
All
Yes - Repair as necessary.
Perform Powertrain Verification Test VER-5A.
No - Test Complete.
Perform Powertrain Verification Test VER-5A.
559
Hope this helps; also keep in mind that your
feedback is important and I`ll appreciate your time and consideration if
you leave some testimonial comment about this answer.
Thank you for using FixYa, have a nice day.
Symptom:
P-0753 TRANS 3-4 SHIFT SOLENOID/TRANS RELAY CIRCUITS
When Monitored and Set Condition:
P-0753 TRANS 3-4 SHIFT SOLENOID/TRANS RELAY CIRCUITS
When Monitored: Continuously with the key on.
Set Condition: This code is set if the voltage detected on the 3-4 Shift Solenoid Control
Circuit at the PCM is different than the expected voltage.
POSSIBLE CAUSES
FUSED B(+) FEED TO THE TRANS CONTROL RELAY OPEN
3-4 SOLENOID WIRING HARNESS INTERMITTENT DEF
3-4 SOLENOID WIRING HARNESS OBSERVABLY DEF
SHIFT SOLENOID CONTROL CIRCUIT OPEN
SHIFT SOLENOID CONTROL CIRCUIT SHORT TO GROUND
SOLENOID AND HARNESS DEF (SOLENOID CONTROL CKT)
TRANSMISSION RELAY OUTPUT CIRCUIT OPEN
TRANSMISSION RELAY OUTPUT CIRCUIT SHORTED TO GND
PCM DEF (3-4 SOLENOID/TRANSMISSION)
PCM DEF (TRANS 3-4 SOL/TRANS RLY CKT)
POWERTRAIN CONTROL MODULE DEFECTIVE
POWERTRAIN CONTROL MODULE DEFECTIVE
POWERTRAIN CONTROL MODULE DEFECTIVE
SOLENOID AND HARNESS DEF (SOLENOID PACK CONN)
TEST COMPLETE
TRANSMISSION CONTROL RELAY DEFECTIVE
2,325 views
Usually answered in minutes!
×