1999 Chrysler Concorde Logo
A
Anonymous Posted on Dec 02, 2011

Driver headlight not working and changed the bulb

The driver headlight went out and replaced the bulb and it still is not working

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

Hot-Shot:

An expert who has answered 20 questions.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

  • Contributor 29 Answers
  • Posted on Dec 02, 2011
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

Hot-Shot:

An expert who has answered 20 questions.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

Joined: Apr 02, 2009
Answers
29
Questions
0
Helped
13998
Points
69

Check backshell of connector and make sure there is not corrosion inside of connector. Wire could also be broke. Right and left headlights are on same fuse and run through same wire. I would suspect no current to connector.

5 Related Answers

Anonymous

  • 2 Answers
  • Posted on Dec 04, 2008

SOURCE: Driver side headlight bulbs burned out on 2003 VW Golf

There is a light cover in front of the battery... take this off and then look for the metal clamps holding the light housing in.  (I say clamps, but they're more like glorified paper clips on either side of the fixture.)  Press in on each side, pushing the clamps towards each other and pull the fixture out.

Ad

Bill Hackett

  • 383 Answers
  • Posted on Apr 19, 2009

SOURCE: 2001 subaru outback headlight not working

chapmnfarm: your head lights use a "2" fuse system.
one for the left and one for the right.
The fuse box you are looking for is under the hood on the passenger's side. It is a black box roughly 8 inches long and 4-5 inches wide. When you remove the cover, you will see fuses and relays. What you are looking for is the section in the box which has a cluster of 7 fuses. 3 in one row and 4 in the other. On the outer parameter are two relays. The fuses you are interested in are located in the row of 4 fuses, with the two closest to the "L" shaped part of the box. Both of those should be 15 amp fuses.
The fuse below those should be a 20 amp which is the lighting switch and the one below it is a 15 amp which is for the interior lights and the clock.
Check your harness grounds in the engine compartment near the area you have the problem. There are ground wires which come out of the harness on both sides of the core support. The wires are black in color and have "EYES" crimped onto the ends of the wires. Both of them will probably be located about 4-6 inches below the upper tie bar on each side of the radiator. Odds are that the eyes will be large enough to pass a 6mm bolt through.
I hope what I have given you will resolve your problem. Lem me know,,good luck>>>>>>>>>>>>>>>

Dane Whitehead

  • 38 Answers
  • Posted on Apr 23, 2009

SOURCE: Headlight bulb replacement for 2002 Hyundai

http://www.autozone.com/autozone/repairinfo/common/repairInfoMain.jsp?targetPage=productsHowToInspect&leftNavPage=productsHowTo&pageId=%090900c15280213e7e&subtitle=replace

Anonymous

  • 6 Answers
  • Posted on Oct 07, 2009

SOURCE: headlight went out in 2003 ford escape i have

you have to remove the whole headlight assembly, then pop off the front cover pull the old bulb out and put the new one in. reverse the process to re-install. there is a small plastic tab on the topfront of the headlight assembly, that is what you need to release to get the clear cover off and get inside.

turboKia

Greg

  • 55 Answers
  • Posted on Oct 23, 2009

SOURCE: How do you replace a Drivers side headlight bulb 2006 kia spectra

Helps to remove the battery, but small ahbds can do it.

Directly behind the lens is a big round cap ... twist it off. The bulb is held in place with a spring that locks in to a notch in the holder. When handling the new bulb, don't touch the glass. The oil from your skin will cause it to shatter when turned on.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers

Head light have low but when using high does not work just on one side drivers side

HELP! headlight not working even after change - Nissan Forums ...

www.nissanclub.com/...nissan.../302674-help-headlight-not-working-eve...

Apr 1, 2010 - 13 posts - ‎6 authors
My passenger side low beam headlight recently went off on me. ... I've changed the bulb again, and changed the fuse just in case, but .... My driver side headlight wire got loose so when i hit a bump at night if would flicker. ... When you notice one side not working (Low or High beam) it could be the module. Headlight replacement
15 posts
Jan 22, 2009
Low beams don't work but High's do
8 posts
Mar 20, 2005
More results from www.nissanclub.com
0helpful
1answer

How do I diagnose why one of my headlights will not work?

the h 7 bulb is a quartz halogen bulb and if touched with the bare fingers has an extremely short life
you have to use gloves when handling the bulbs as the oil from the fingers reacts with the glass when in use and blows the bulbs
they will also blow from bad/ loose ground points and if allowed to arc ( as in welding ) will fail quickly
you should get 12 volts to both bulbs at one terminal while the other is the grounding wire
check for problem relays in the power wire
0helpful
1answer

One of my turn signals wont work, both my headlights only work on highbeams

replace the high beam switch which causes this problem. Also clean the terminals for the directional light bulb. That will cause a negative continuity to the bulb
0helpful
1answer

Driver's low beam headlight blows the fuse

try another fuse. check that all bulbs work. If fuse blows again in a short time, you have a short in that circuit- a broken wire or wire that lost insulation and is contacting metal. It may or may not be near the bulb you replaced.
0helpful
1answer

How to change the low beam bulb on driver and passenger sides

the low beam bulb is one with the high beam ,so you need to replace the headlight bulbs, its hard to believe they both went at the same time,i would buy one and replace it if lights still don't work than you might have other issues like maybe a blown fuse.
0helpful
1answer

Breeze's brake light went out. changed bulb, now whole tail light won't work.

sounds like you put the wrong bulb in, that will make it blink fast. re check
0helpful
2answers

Headlight Issue

No, you just might have to take out the battery. I was able to do it without taking the battery out, but only because I was being stubborn. There is one thing I definitely have to say is that you should change both headlights at the same time. My driver side headlight was the first one to go and I didn't listen and just changed that one, days later my passenger side one went out!
1helpful
1answer

Help with 1995 Caprice Classic Headlight Replacement

you turn the black harnes clock wise and then the light bulb and harnes shuld come out
Not finding what you are looking for?

237 views

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...