SOURCE: Put new rear rotors and pads on my 2002 I35
Doesn't sound like the brake lines were bled properly. Many times after pad and rotor installation if the lines are bled correctly you will have to pump them initially after the repair for a couple of minutes until the pressure is built back up. Also check the master cylinder and make sure fluid level is ok.
SOURCE: I have 2002 infinity I35
WELL YOU HAVE TO USE A VOLT METER CONNECT ONE VOLT METER WIRES TO GOOD GROUND AND THE OTHER VOLT METER WIRES GOES TO EACH SWITCH SPEED.IF VOLT METER GET VOLTAGE A 1 OR 2 CONTROL SPEED RESISTOR BAD.IF RESISTOR BAD YOU WILL GET 1 OR 2 BLOWER MOTOR SPEEDS.IF BLOWER MOTOR WORKING.CHECK THE AC AND HEATER CONTROL SWITCH FUSE OR CHECK BLOWER MOTOR FUSE AND RELAY.IF ALL GOOD SO FAR CONTROL SWITCH ITSELF COULD BE FAULTY.
SOURCE: How to program 2002 i35 infiniti keyless remote?
The procedure goes like this. First get in the car and lock all the doors. Secondly insert and remove the key repeatedly until the turn signal indicators on the dash flash twice simultaneously, it should be like seven or eight times. Then turn the key on and press the lock button on the remote and the lights should flash again. After that turn the key off and manually unlock and open the drivers door, then shut it. Wait a few seconds then try the remote.
SOURCE: how do you get at the radiator drain plug on a
Hi...
This picture should help you.
Thanks
Smith
SOURCE: How do I replace my cam sensors and crank sensor
simple check to see if is the bank 1 or bank 2 cam sensor
do you a code for cam sensor
252 views
Usually answered in minutes!
×