Question about 2000 Jeep Grand Cherokee

Open Question

2000 jeep grand cherokee. powers windows stopped working and interior lights stay on

I repaired a little black wire that was located in the door jam but windows still arent working and interior lights stay on. and now the steering wheel radio controls and high beam indicator light on dash arent working either. i am assuming I have unplugged something or have blown a fuse.

Posted by on

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
Mike258

Justin Case

  • 1498 Answers

SOURCE: i have a jeep grand

If it only goes stiff part of the time, the box is probably OK.

Before considering major surgery:

  • check the power steering fluid level.
  • condition of the fluid
  • condition and tension on the belts
  • check for low or uneven tire pressure
  • check steering linkages for damage (did someone borrow the car recently?)
If none of these check out, then consider replacing the pump.

Mike

Posted on Jul 14, 2008

Ad

Anonymous

  • 1 Answer

SOURCE: Dome light stays on, power windows don't work... 1999 Jeep

Check for a broken 12V+ or broken ground wire in the rubber boot that goes from the drivers door to the hinge pillar. Had this problem on mine and found both wires broken from years of flexing when door opened and closed. Don't try to splice the break, as the wire is too short and is also brittle. Run new (same guage) wire through the boot and splice inside the door and under the left side kick panel.

Posted on Dec 31, 2008

Anonymous

  • 2 Answers

SOURCE: 96 grand jeep cherokee is jammed into park

There was a recall that had to do with the shifter for my 96 GC Laredo. I had the dealer do it a couple of years ago for free...

Posted on Jan 07, 2009

Anonymous

  • 74 Answers

SOURCE: The interior lights for my 1996 jeep grand Cherokee Laredo

Hello and welcome to FixYa
The interior lights wont turn off cant because it can't get a conncetion definitely a headlight switch issue common problem for that make
Part # 05137535AA Headlight Switch Probably a dealer item very simple to change this yourself. Hope this gets you going.Please Rate Me. And you can always Ask Me.
1ak+f4pj7cbm32cuniyi2gaaaaaelftksuqmcc

Posted on Apr 27, 2009

Anonymous

  • 186 Answers

SOURCE: 2009 Jeep Grand Cherokee Laredo interior lights won't turn on

check your light dimmer & see if you have it set all the way down.If it's anything like my 99WJ it has an off setting when the dimmer is set all the down causing the interior lights to not come on when you open the doors,hope this helps

Posted on May 16, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

2004 jeep grand cherokee windows will not work, door locks will not work, mirror controls will not work, interior lights will not go OFF!!!! I can't locate the fuse. Any recommendations


Also check the ground wire that goes through the rubber boot at the door hinge, mine broke on both sides and screwed up the electrical system

Jul 14, 2010 | 2004 Jeep Grand Cherokee

1 Answer

My door locks on the passenger side wont work, and my interior lights wont turn off, the windows also wont work. I have a 2002 jeep grand cherokee


you have a broken grond wire in the front pasanger door boot in the front door jam. very common on these and have to repair thwm all the time. you have to pull back the black boot and inspect all the wires and pull on the. sometime the break is up further and you can't see it because the boot don't pull back far enough. it most likely with be a black wire. good luck

Mar 14, 2010 | 2004 Jeep Grand Cherokee

3 Answers

04JeepGrdCher:Interior lights stay on and power windows dont work


I had this same problem but no sunroof on mine. there is a bundle of wires that goes into the door and if the power wire breaks and the power window lockout was pushed when it happens no windows work and the dome lights stay on on mine it happened on the drivers side it was an easy fix i took the door panel off and unpluged the harnes and pulled it through the inside of the jeep and spliced the wire back together and it has been working since.

Dec 05, 2009 | 2004 Jeep Grand Cherokee

1 Answer

2002 jeep power windows and door locks stopped


SOUNDS LIKE YOU HAVE BROKEN WIRES BETWEEN DRIVER'S DOOR AND BODY AT A PILLAR..PULL RUBBER BOOT FROM BODY AND DOOR AND INSPECT WIRING HERE

Jun 19, 2009 | Jeep Cherokee Cars & Trucks

1 Answer

Door jam switch


broken wire in between body and door wiring

Jun 01, 2009 | 2000 Jeep Grand Cherokee

1 Answer

Crazy electrical problem


you have a broken wire in door to body wiring loom repair this and all will be back to normal

May 28, 2009 | 2004 Jeep Grand Cherokee

1 Answer

2000 Jeep Grand Cherokee Laredo Door Locks Dont' Work Correctly


you need to check wiring between lf door and body..peel back rubber boot and pull on wires..you will find 1 or more broken wires..can be repaired

Apr 08, 2009 | 2000 Jeep Grand Cherokee

2 Answers

04 jeep gc interior lights stay on, power windows,locks not work


Common issue with the early 2000 series Jeep is the window/door lock control on driver side goes dead when the thick guage wires in door become brittle and break from continually opening and closing the door. Had both the ground and hot wires break over the years and both are fixed by making a simple jumper connection with a little extra length added.

Fixing is relativly easy if you know how to crimp wire connectors otherwise you my want someone more experience to help.
Open door, pull back rubber sheath and expose wire harness, unclip the plastic retaining clip and pull out wire harness and located which wire has broken (typically the thick black or orange wire) . Prepare both ends for crimp connector and make a jumper with small peice of heavy guage wire and crimp connector of either end then connect each end to either side of broken wire, tuck wires back in, replace retaining clip and rubber sheath.

You can find videos on youtube showing how to fix

Jan 01, 2009 | 2004 Jeep Grand Cherokee

3 Answers

Power windows dont work and dome light stays on


It has to be a broken wire! Initially, I lost the door locks & power to the windows ONLY when the drivers door was open. When I closed the door, the problem went away. Finally, I had the problem all the time. I checked for 12 vdc at the switch in the drivers door and there was NO POWER. In the rubber boot (between the car & door) I found the grey wire (with a pink stripe) was broken internally but the INSULATION WAS NOT!!!

Dec 29, 2008 | 2004 Jeep Grand Cherokee

Not finding what you are looking for?
2000 Jeep Grand Cherokee Logo

230 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

Marvin
Marvin

Level 3 Expert

85223 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...