1994 Toyota Previa Logo

Related Topics:

Anonymous Posted on Nov 24, 2011

How to fix code P1300 on a 94 Toyota previa LE

5 Related Answers

Anonymous

  • 362 Answers
  • Posted on Mar 14, 2009

SOURCE: I need to find where to check transmission fluid

The dip stick is under the driver's seat.

88599b0.png

Ad

Anonymous

  • 3533 Answers
  • Posted on May 02, 2009

SOURCE: How much would it cost to replace a 97 toyota previa LE awd engin

it would cost somewhere around $1.200- to 2.000 dollars call around to different repair shop and see if you can find a good deal or someone who can do it on the side for you and try this website to see if your car is listed it www.autozone.com or pickup a haynes auto repair manual and you see its not hard to do.

Anonymous

  • 1 Answer
  • Posted on Oct 14, 2009

SOURCE: I need a SLIP-YOKE for a rear driveshaft of a 1995

by slip -yoke for rear drive shaft, I think you describe a spline joint with universal joint yoke attached, I have all drive shafts for an AWD previa. Write [email protected]

Anonymous

  • 3092 Answers
  • Posted on Apr 06, 2010

SOURCE: 97 TOYOTA PREVIA LE. Steering wheel tends to ****/vibrate

Make sure that engine is not running with a cylinder miss fire, if that ok have your motor mount's check.

Testimonial: "Engine has no miss fire and will check mounts."

Anonymous

  • 242 Answers
  • Posted on Jan 16, 2011

SOURCE: How do you fix an Igniter Circuit Malfunction -

The problem 95% of the time is an ignition coil, if you do not have special equipment, your only tool is common sense, disconnect plugs from spark plugs, remove spark plugs,now insert the plugs in the wires and set them together touching metal ground them,
Ask somebody to crank vehicle one of those wires or 2 of them if the coil is bad wont fire or the spark will be weak and orange, blue is ok. Follow the no spark or weak spark to the coil, now swap coils , repeat the same procedure if the problem follow the coil to the wires that were ok before the problem is the coil if the problem is still in the same position the problem is harness wires or computer.

If you need further help, I’m available over the phone at https://www.6ya.com/expert/flavio_517b938f50183b92

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

It turns over but I can’t stared 97 Toyota previa le

Does it have spark ? If it does can you spray some starting fluid into the throttle body and see if it starts ?
0helpful
1answer

1993 toyota previa LE minivan: the OVERHEAD A/C between the front seat row and 2nd row is a "real a/c" (with the compressor) or just the air-flow ventilator?

There is only one compressor, there is an a/c evaporator in the overhead unit that gets Freon from the compressor which cools the evaporator so cold air will come out when the fans in the rear are on.
1helpful
1answer

The compression is the same for all cylinders(150), but when I turned motor over, water came out of #1 cylinder only. Any idea?

Toyota Previa Questions - 93 toyota previa having white ...

www.cargurus.com > Questions > Toyota > Previa

CarGurusMar 17, 2013 - 93 toyota previa having white smoke while starting and stu-off while running on the road. ... Lift the cylinder head off the engine block and move to oneside. Remove the ... 1992 Toyota Previa 3 Dr LE Passenger Van ... was going down the road one day and it just shut off. it will turn over but wont crank.Missing: water

Rough idle, bad hesitation on acceleration, perfect idle with ...

repairpal.com > Questions > Toyota > Previa > 1994 Toyota Previa
1994 Toyota Previa Questions ... Idle is perfectly smooth for first 1 - 2 minutes after overnight cold start, before .... This may be because the throttle position sensor is signalling just off idle. .... My check engine light came on with PO-420 code. ... theengine was turning over under starter motor that would bring the engine to an ...

Re: Replacing a Previa head gasket. - ToyotaVanTech

www.toyotavantech.com > Forum > Technical Discussion > Toyota Previas

Dec 3, 2011 - 20 posts - ‎2 authors
Okay, so you've got a Toyota Previa with a blown head gasket. ... The next few pix are taken after dropping the engine out from the bottom using a ... You can see a definite path between the water jacket and the cylinder. ... I believe this was a result of #1blowing and over pressurizing the cooling system.

How to Change a Coolant Temperature Sensor - YouTube

? 26:00
https://www.youtube.com/watch?v=IXSp5ykI6po
Sep 16, 2012 - Uploaded by rehma6b0
0helpful
1answer

I have a 93 toyota previa LE the ECM CODE is 52 that is knock sensor malfunction but sometimes does work great and sometimes don't please help, Thanks.

Since it is intermittent. It's probably the plug. They are single wire. Find it, unplug it and plug it back in. Could be corrosion. It if still acts up, then the wire usually breaks right behind the plug. You can take it apart and fix it (I do) or find another plug and replace it.
0helpful
1answer

How to replace the drive shaft coupling on a 1995 toyota previa

I replaced my drive shafts on my 96 Previa LE SC, so I know it can be done. If you don't know the difference between the auxiliary drive shaft and the front or rear drive shafts, then you probably want to have someone do it for you. The auxiliary drive shaft coupling replacement is a difficult job. It is covered in manuals available in auto parts stores. $20 for the manual is worth it if you decide to do it yourself.
1helpful
3answers

Where are location crankshft sensor??

DISTRIBUTOR IS THE CRANKSHAFT SENSOR.
3helpful
1answer

97 TOYOTA PREVIA LE. Steering wheel tends to ****/vibrate

Make sure that engine is not running with a cylinder miss fire, if that ok have your motor mount's check.
0helpful
1answer

I need a SLIP-YOKE for a rear driveshaft of a 1995 Toyota Previa LE supercharged AWD.

by slip -yoke for rear drive shaft, I think you describe a spline joint with universal joint yoke attached, I have all drive shafts for an AWD previa. Write [email protected]
3helpful
1answer

I need to find where to check transmission fluid

The dip stick is under the driver's seat.

88599b0.png
Not finding what you are looking for?

167 views

Ask a Question

Usually answered in minutes!

Top Toyota Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...