How to reset brake lamp warning indicator audi 2007 audi A3 s-line 3.2

I have the same problem few days ago, and still didn't find any solution. Can any one please help?????3

It's an yellow warning indicator lamp. It lights when brake pads are weared. Now it's time to replace the used brake pads!

It's an yellow warning indicator lamp. It lights when brake pads are weared. Now it's time to replace the used brake pads!

It's an yellow warning indicator lamp. It lights when brake pads are weared. Now it's time to replace the used brake pads!

The sensor is in the locking mechanism, alot of vw and audis have this problem with the hoods and the trunks, you have to remove the panel where the mechanism is and disconnect the cable and leave it disconnected, the light should turn off

Take it to auto zone and have the code's reader hooked up on it and that can tell you the problem

Press and hold the SELECT/RESET
control switch to select SYSTEM
CHECK when “SYSTEM CHECK /
HOLD RESET” is displayed in the
message center. Selecting this
function from the SETUP MENU
causes the message center to cycle through each of the systems being
monitored. For each of the monitored systems, the message center will
indicate either an OK message or a warning message for two seconds.
Pressing the SELECT/RESET control switch cycles the message center
through each of the systems being monitored.

The sequence of the system check report and how it appears in the
message center is as follows:
1. OIL LIFE RESET
2. CHARGING SYSTEM
3. WASHER FLUID
4. DOOR AJAR
5. EXTERIOR LAMP
6. BRAKE SYSTEM
7. PARK BRAKE
8. MILES TO EMPTY
9. FUEL LEVEL LOW (will only display if 50 miles or less to empty)
To reset the oil monitoring system to 100% after each oil change
[approximately 5,000 miles (8,000 km) or 180 days] perform the
following:
1. Enter SYSTEM CHECK to display
“OIL XXX% RESET IF NEW”.
2. Press SELECT/RESET control
switch to display “HOLD RESET IF
NEW OIL”.
3. Press and hold the
SELECT/RESET control switch for
more than 2 seconds. Oil life is set
to 100% and “OIL CHANGE SET TO
100%” is displayed.

lookes like a anti-lock braking light or wear indicator light

It might be the brake pad sensor,I'll clarify it tomorrow.

You need to check your owners manual for the difinition of this light, it may just be the oil change light, or it could be a pressure or oil level light, have you checked the oil level just to be safe?