Put. In a heat coil lincoin. Navigator 1998

No there is not, you need to fix the problem.

You have to have your owners manual on a Ford to tell what goes where. They were not smart enough to print it on the cover like Chevrolet and Chrysler does. You might be able to find and image by Googling it though.

The plugs should come out without disturbing the fuel rails. Just pull the plug wires one at a time.

should be in or near the fusebox.

You should be able to find a used book on Ebay.

Replace the solenoid pressure control shift pack inside the trans pans

Common problem

One part --- about $515.00,$332.00 wholesale

Remove trans pan
Remove filter
Loosen wire harness bolt only
Pull down shift pack & replace

Need Torx socket driver to remove 7 bolts

NOT ENOUGH FULE CHANGE THE FUEL FILTER OR THE PUMP IS GETTING WEAK

ok you will see 8 coil packs on top of the engine 4 on the left and 4 on the right they have a 2 wire conector disconect the conector remove the 8 mm screw now lift out the coil set it aside now the spark plug is way down that hole that you removed the coil from i think it is a 9/16 spark plug odd but that is what ford did make shure you put anti seze on the new plugs and you gap them

The Lincoin Town car trans. shifts fine till overdrive then it's like putting it in nentrul

it's on the driver side, either in the engine compartment or in between the inner fender liner and the fender.

Please rate as fixed if this helps.