Where do I locate the throw adjustment on the slave cylinder,I have not replaced the slave cylinder but noticed the clutch was to the floor and thought it may need to be adjusted.
SOURCE: hydraulic clutch for jeep wrangler 2000
The bleeder screw is located on top of the slave cylinder. It will not work right until it is properly bled.If the reservoir runs dry, you will have to start all over. Have an assisstant pump the clutch pedal 3 times with the bleeder screw closed...then hold the pedal down and open the bleeder screw. Don't release the pedal until the screw has been retightened...continue this process untill no air bubbles come out of the bleeder screw....don't let the resevoir run dry...Please rate this...
SOURCE: Hydraulic clutch problems
i have a ktm 125 wich all ktms have hydraulic cluthcs and i have the same problem as all these fellas even when im riding it just sucks right down all the fluid reply to me on [email protected] ok thanks fellas
SOURCE: replaced slave cylinder 2004 ford ranger 4x4 still no pedal
I had the same problem with my 1995 1500 p.u.. Assuming your clutch slave cylinder is the concentric style. If not disregard. I hate that set up. what the hell was wrong with the old outside of the bell housing slave/ mechanical style fork and throw out bearing bla bla? Its because ford as well of the rest of the lovely auto makers decided long ago to make them as hard as hell to repair on you own. Ive been told theres a spsecial tool just for this bleeding task. Pobably. They make those tools to sell to us so they can further profit from us poor suckers.Also I wonder on your model if its concentric, does it have the difficult sized bleeder valve as mine did? or have they gotten a little more user friendly? doubt it. In my case as this style is a closed system I followed the bleeding intructions to a tee. That did get alot more clutch action for me, after 15 attempts.However I do believe the problem after looking and further inspection under the dash? look up under the dash and inspect your pedal rack and frame. I found mine was cracked and the cause of poor aliegnment. check for that rite away. I located another rack but before I got around to replacing it, the tranny blew, and the trucks sitting on my dads property. Its still a danmed good truck and one of these days I will get on it again. Anyway up untill the tranny blew I was never able to get more than half the distance from the pedal and besides the rack problem I would love to know the bleeding anser, that is if Im off target. Going to be up against it again when I replace that transmission. Hope this helps a little. Food for thought maybe? If you find out something more helpful post it so I will know too.
SOURCE: Clutch adjustment 95 Jeep YJ
no, there is no clutch adjustment. the clutch is hydraulic, and self adjusting, there are several things that can go wrong with these. with normal wear the fluid can run low allowing air into the system, causing a weak peddle. they can also develop leaks in the master and slave cylinders resulting in fluid loss also causing a weak peddle leading to an inopperative clutch. check the fluid level in the clucth master cylinder(next to the brake master cylinder. if it is empty, refill it(it takes brake fluid) then cycle the clutch peddle a few times and check for leaks. if there is air trapped in the line the clutch will need to be bled. there is a bleeder screw on top of the slave cylinder, bleed it just like bleeding brakes.
SOURCE: How do I bleed the clutch slave cylinder on my 2005 VW Jetta 2.5L
the clutch and brake resevoir are all in one.
269 views
Usually answered in minutes!
×