SOURCE: 2000 toyota echo, wheel bearings
I found this site to be very helpful with this job: http://www.toyotanation.com/forum/showthread.php?s=714b28cb1c3f77f992209de0bdbfbd13&p=2481776#post2481776
SOURCE: what torque for rear wheel bearing Ford Focus 2000
Can only find out that the hub needs to be tightened to
235 nm Dunno if this helps
SOURCE: need torque setting for 1993 geo tracker front
i1m sorry to say that wheel bearings are not set to a torque specification, when you have repacked the bearings [ inner and outer ] ,reassembled it ,take the nut up until thewheel starts to drag and not turn very far when you try to spin it spin it backward and forward several times,grab the top of the wheel and try to push it in and out,if you getany movement at all tighten the nut a couple of castilations. do it all over again, spinthe wheel a few times and then try for the crossways movement again, if there is no movement ,you are very close to being right....................now comes the experience bit , iwould take it one more castilation of the nut because i know the feel that is need ed,,without that i suggest you put the pin in where you ereput the cap on and go for a 5 minute drive . whenyou get back ,jack it up and thespinning of the wheel again and try for the top crossways movement ,if there is any tighten thenut 2 castilations, and provided that when you try to spin the wheel by hand with a reasonably strong push the wheel should trael about 6 inches at least after your hand leaves it ,it is now a close as you are going to get itput it all to gether and for the next day or so put yor hand on the grease cap after you have driven anydistance, and you will feel it is warm but you should be able tohold your hand on the grease cap. there you have it ,any questions come back."youdoit"
SOURCE: Does anyone know the torque wrench settings for
Tightening torque for the hub nut is 200Nm and the road wheels are 85Nm
NOTE:
The rear wheel bearings are remowned on these cars for sticking to the
stub axle quite badly, and often have to be forced off using a slide
hammer on the drum, it is quite common to end up damaging the wheel
bearing, so be prepared to replace this as well in this event
2,269 views
Usually answered in minutes!
×