Does the van have remote keyless entry (RKE) system ?
Interior Lighting System Description
Vehicles with the optional remote keyless entry (RKE) system have interior lighting controlled by the body control module (BCM).
This vehicle uses a delayed interior lighting system.
The system functions as follows:
• The dome lamps will illuminate when any door is opened.
• The dome lamps will remain on for 20 seconds after the last door is closed.
• The delay is canceled and the dome lamps will go out when the ignition switch is turned to the ON position.
• The illuminated entry function will not operate when the dome lamp defeat switch is in the OFF position.
• The interior lighting system is protected from battery rundown by the retained accessory power (RAP) system. The RAP system functions by shutting down interior lights after 10 minutes (when ignition is OFF).
Interior Lights Circuit Description
When the interior lamps circuits are closed/enabled, the courtesy lamp relay is activated by the two following coil circuits:
• CKT 690 (GRY/BLK) which is the courtesy lamp enable output of the body control module (BCM) driving the coil side of the relay.
• CKT 1732 (ORN) which is the coil output side of the relay going to the potential grounding switches/sources.
When the courtesy lamp relay is enabled, CKT 156 (WHT) (courtesy lamp output) is enabled by the closed contact at the relay and then grounded by CKT 750 (BLK) at G110.
Some of these circuits can also be activated with the headlamp and panel dimmer switch. When this happens, the coil output side of the inadvertent power relay is grounded to the body control module (BCM) via CKT 1393 (DK BLU)
CKT 40 (ORN) from the courtesy fuse drives both input sides of the inadvertent power relay. When the contact is pulled closed, CKT 1732 (ORN) is supplied power, thus driving any lamps/circuits attached that circuit and providing ground.
The body control module (BCM) also monitors the following four door inputs:
• CKT 49 (DK BLU) -- LH door jamb switch input
• CKT 54 (ORN) -- RH door jamb switch input
• CKT 775 (PNK) -- Side door jamb switch input
• CKT 656 (YEL) -- Rear door jamb switch input/liftgate strut switch input (depending on option content)
When the doors are closed, the body control module (BCM) is in a floating state of 0-2 volts. When the doors are opened, the courtesy lamp relay is activated, sending power to the courtesy lamps.
The headlamp and panel dimmer switch also activates the following interior courtesy lamps when the switch is placed in the PARK or HEADLAMP ON positions:
• RF power window switch
• RH power door lock switch
• LH power window switch
• LH power door lock switch
• LH outside rearview mirror control switch
• Rear radio control head
The dome lamps can be disabled by closing the dome lamp defeat switch located on the headlamp and panel dimmer switch.
--------------------------------------------------------------------------------
Courtesy or Dome Lamps Inoperative
Step
Action
Value(s)
Yes
No
Important: Verify functional bulbs before beginning diagnostic procedure.
1
Did you perform the Lighting Diagnostic System Check?
--
YES - Go to Step 2
NO - Go to Diagnostic System Check - Lighting Systems
2
Are all of the courtesy/dome lamps inoperative?
--
YES - Go to Step 6
NO - Go to Step 3
3
Activate courtesy/dome lamps
With DMM, check for battery voltage from inoperative lamp CKT 1732 (ORN) to ground
Is battery voltage present?
B+
YES - Go to Step 4
NO - Go to Step 5
4
Repair open in CKT 156 (WHT) between inoperative lamp assemply and S214.
Is the repair complete?
--
NO - Go to Step 10
--
5
Repair open in CKT 1732 (ORN) between inoperative lamp assemply and one of the following splices:
• S258
• S301
Is the repair complete?
--
Go to Step 10
--
6
Turn the courtesy lamp switch to the ON position
Check for battery voltage at BCM C2 cavity B12.
Is battery voltage present?
B+
Go to Step 7
Go to Diagnostic System Check - Body Control System in Body Control Systems
7
Verify continuity of the following three circuits with DMM:
• CKT 1732 (ORN) between courtesy lamp relay and body control module
• CKT 156 (WHT) between courtesy lamp relay and S214
• CKT 750 (BLK) between courtesy lamp relay and S206
Are all of the circuits functional?
--
Go to Step 8
Go to Step 9
8
Replace courtesy lamp relay.
Is repair complete?
--
Go to Step 10
--
9
Repair the inoperative circuit.
Is the repair complete?
--
Go to Step 10
--
10
Operate the system in order to verify the repair.
Did you correct the condition?
--
System OK
Go to Step 2
SOURCE: dome light does not come
Likely failure is either in the dome light bypass button next to the headlight switch on the dash, or failure of the plunger switch located in the door jam. If the dome light is not comming on when any of the doors are openned (passenger, side or rear doors) then I would start with the bypass switch on the dash. Can be checked fairly easily with a multimeter -- after you've managed to remove it from the dash.
Good Luck
Wray Breen
SOURCE: My 2000 GMC Savana Van keeps blowing a fuse that
it sounds like you have a short some were im guessing it's in your tail light were it plugs in check and see if theres any open wireing from the light to about 3to 6 inches away
SOURCE: my interior lights stay on even with the doors
This is a short on the dome lamp assembly. It is possible that the ground wire from the dome to switches is short.
remove assembly and check.
197 views
Usually answered in minutes!
check the courtesy lamp relay located in the Relay Block 1
Under left side of dash on data link connector bracket facing rear of vehicle
×