Where is the neutral safety switch on a 1993 Jeep Grand Cherokee laradeo ?

a/t (automatic)
is the PRNDL switch on the side of the trans. the N part, does that.

Your neutral safety switch needs replacing.Here's the part. Duralast Neutral Safety Switch CR401 2004 Jeep Grand Cherokee 2WD 8...

Can't,it's good or bad.Here's how to replace.Here's the part.

could be a bad neutral safety switch. did you try to start the truck in neutral ?

http://jp.automotive.com/93239/154-0805-1987-2001-jeep-cherokee-neutral-safety-switch/index.html

just clean out the switch.

Does the check engine light on your dash light up when you turn on the ignition, before trying to crank the engine? Does the fuel pump come on for a second, and prime the fuel lines, when you turn the ignition on? Does the fuel injector wires get the pulse signal from the ecu while cranking? If not, your jeep ecu might be in need of repair. It's a common problem with that generation of grand Cherokees.

Neutral safety switch is not making contact in park.

Check the fuses for the overhead console, could be that if not then the console needs to be replaced.....

The switch is on the transmission..It is usually a dealer item but you can get one from Rockauto.com for about 1/4 of what the dealers charge.

See if this information helps you any. If not post back up.
http://www.automotivenotebook.com/thread-13.html