2001 lincoln ls harmonic balancer pulley out of line

The lowest pulley on an engine is usually the Crank Shaft Pulley (CS). This is the pulley that makes the serpentine belt move and the other end of that shaft is what turns the transmission.

Harmonic balancer bolts are typically considered a "consumable" item, meaning they are designed to be used once and then replaced. It is possible that the specific bolt you need for your 2006 Lincoln LS has been discontinued by the manufacturer. In this case, your best option would be to try and find a used one from a junkyard or online auto parts marketplace.
Another option would be to contact a local or online specialty auto parts store, as they may be able to order the discontinued bolt from a supplier. Additionally, it's possible to use a aftermarket harmonic balancer bolt from a different brand.

https://www.lislecorp.com/specialty-tools/pullers-and-installers/harmonic-damper-pulley-puller-537 https://www.lislecorp.com/specialty-tools/pullers-and-installers/harmonic-damper-pulley-puller-537

ON most engines there is only on pulley as part of the harmonic balancer. It is the on that has the rubber between the pulley and the center bit on the crank. Any other pulleys are normally bolted to this pulley on the center hub piece . I'm thinking that the mount bolts have fallen out.

the garage may have did something to the crank position sensor that is located behind the harmonic balance. there is a ring gear there to for the timing

You'll probably need to use a large gear puller - the balancer may be forced onto the crankshaft by the center bolt.

Although i would love to do so i cannot confirm that at this time. the part does not fit the 2006 lincoln ls but can be used on the ford crown victoria. the part ran at about a hundred and thirty dollars but there is also equipment required for the removal of the this part. this is a more prevalent part on chevrolet motors !

CRANKSHAFT PULLEY IS THE HARMONIC BALANCER.YOU NEED THESE TOOLS TO REMOVE HARMONIC BALANCER, YOU NEED HARMONIC BALANCER REMOVER AND INSTALLER TOOL.YOU NEED A LARGE PIN SPANNER WRENCH TO HOLD HARMONIC BALANCER IN PLACE WHILE LOOSEN THE HARMONIC BALANCER BOLT.

hi this depends on what harmonic balancer you are inquiring about, normal balancers do have a woodruff key,but the pulley type harmonic balancer only bolts to a cam hub on what ever it is connected to, such as water pump, etc etc... hope this helps

the pulley on the crankshaft should have grooves in it for the belt, otherwise the belt will not turn. is the pulley broken off, get back to me. there are NO technical servise bulletins on this item,if you need more help get back to me, Thanks Ray