SOURCE: Clutch pedal low near floor, can the clutch be adjusted?
hi the clutch on accent is hydraulic operation so if pedal is very low on disengaging clutch ? you may have a problem with the hydraulics 1st thing to check is fluid level? this is the reservoir that feeds both brakes and clutch but is seperaterated inside if fluid low? top up and bleed the slave cyl however if fluid low indicates a leak ? possibly slave cyl? if no loss of fluid ? then prob may be fault in the master cyl ? check fluid come back with any update please ps if this problem has just occured? check for leaks ?
SOURCE: 2002 hyundai accent codes p1529 and p0734
P1529 means nothing more than the TCM (transmission control module) has
requested that the ECM (engine control module) turn on the check engine
lamp.
P0734 basically indicates that your transmission is slipping.
You need to take this car to an authorized repair center for hyundai cars. Replacing the filter and fluid on the transmission might save this transmission but I would be willing to bet that a total transmission rebuild is in order.
Good Luck
SOURCE: In a 2000 Hyundai accent, clutch fluid = brake fluid
Yes that is correct. it should say what type right on the lid. example dot 3 or dot 4.
SOURCE: 2002 Hyundai Accent Problem
first thing i need to know is did the timing belt break?
second is are you sure you aligned the timing marks and after the belt tensioner was tight you rechecked to make sure the timing stayed where you had it.
next step would be a compression check to if a valve was bent whenchanging the belt
i have seen this happen and this engine is an interferance engine.
later paul
SOURCE: timing belt on my 2002 hyundai accent 1.6 liter 4cyl
Was It Starting Before?
Who Changed It?
If The Belt Broke And The Belt Was Just Put Back On Without It Being Put In (TDC) Top Dead Center The Car Will Not Run. Warning! Trying To Start It Over And Over Will Destroy The Engine.The Engine Works By Being (TDC) Top Dead Center The Timing Controls When The Cylinders Come To The Top. The cylinders Are Controlled By The Timing So When The Spark Plugs Try To Ignite. The Cylinders Are Not In Position And Thus Will Not Create Combustion For The Engine To Run.
2,757 views
Usually answered in minutes!
×