Warn hubs, installation - Cars & Trucks

Shop around the hubs are $120 or less and very easy to do as above, fougth the vacuum system for years, have not regreted for one second going to manual

Warn Hubs Installation
A truck or SUV with a four-wheel drive suspension uses locking hubs on the front wheels to engage or disengage the front axle shafts from the hubs. This way, you can drive the truck normally with just rear-wheel drive, or engage four-wheel drive mode when you want to drive off-road. These hubs can wear out, and one improvement is to install a set of Warn hubs. Installing a set of Warn hubs takes about an hour.
1.Park the truck and put on the parking brake. Lift the front of the truck with the jack and put the jack stands under the front axle. Take off the front wheels with the tire iron and put them to the side.
2.Disengage the locking hubs using your hands by turning the knob on the hubs. Remove the snap rings holding the hub locks in place with the snap-ring pliers. Pull the hub off the axle.
3.Install the lock ring wheel from the Warn hub kit in the axle with the factory snap ring and the snap-ring pliers.
4.Make sure the Warn locking cap dial is turned to the "Free' position. Install the locking cap onto the lock ring wheel and hub body with a hex-head key. Reinstall the front wheels with the tire iron and lower the vehicle off the jack stands with the jack.
Thank you for using FixYa. Hope this will help your problem and don't forget to rate me.thanks,
Reymond