SOURCE: 2001 kia sportage blower motor resister
Rule of thumb...unless you get a better answer: look for a couple of wires on a small plate that is in the airflow of the fan on the heater/ac unit. The resistor pack is always air cooled by the fan.
SOURCE: 06 kia sportage airbag control module
If your refering to the light on top of the dash that says "psgr air bag not connected" here;s the deal.
The module is activated when someone sits in the seat. Turn the key on and the notification will light. Go around to the psgr side of the car and sit in the seat and the light should go out.
SOURCE: Starter for kia sportage 2000
Negative battery cable
Intake manifold bracket upper bolts
Clutch release cylinder and move it aside, if equipped
Intake manifold bracket lower bolts and remove the bracket
Starter from the clutch, manual transmissions only
Starter from the torque converter, automatic transmissions only
Starter electrical connectors
Move the transmission wire harness aside
Starter
Fig. Exploded view of the starter
To install:
Starter to the engine well
Starter electrical connectors
Lower intake manifold bracket and install the upper bolts
Starter into position. When aligned properly torque the bolts to 40 ft. lbs. (54 Nm).
Torque the intake manifold bracket bolts to 40 ft. lbs. (54 Nm).
Properly position the clutch release cylinder, if equipped. Torque the bolts to 40 ft. lbs. (54 Nm).
Torque the intake manifold bracket upper bolts to 40 ft. lbs. (54 Nm).
Negative battery cable
SOURCE: how to adjust the clutch of a 1998 kia sportage
clutch is located at the one side of the engine just tight the screw located there do ur work along with one more person so that he can clarify that it works properly
Search the block for the engine block casting number. The numbers are raised, not stamped into the block and consist of seven numeric digits. The digits can be located on either side of the block. The seven-digit number may be followed with a dash and further numbers. These are change codes and are not normally necessary to identify the engine.
EX.:
Locate the casting date is located on the block. It is in standard date coding, 2.25.93, for example and may be located on either side of the block, but is commonly located on the driver's side of the block, above the freeze plugs. The example 2.25.93 decodes as February 25, 1993. The casting date may be near the casting clock, which designates the hour the block was cast. Magnum engines were manufactured from 1993 to 2002, so verifying the date code helps identify the engine.
416 views
Usually answered in minutes!
×