Hello! First see Serpentine Belt configuration diagram below... Alternator is part "C"...
If you have a voltmeter...read across the battery with engine off...Record...Start engine read again...Voltage must be 1.8 -2 volts higher; This means Alternator is working...
To Remove:disconnect (-) battery cable...Air Inlet Duct...Serpentine Belt (idler pulley maintains tension)...Heater hose brace...Wiring from Alternator...Mounting bolts...Remove alternator...
To Install: Install Alternator loosely...Tighten Rear Bolt to 37 ft. lbs...Front bolt to 18ft. lbsTighten Brace to Intake to 18ft lbs....Connect wiring...Install belt...Adjust Idler Pulley so belt moves less than 3/4" when tight...Connect (-) battery cable....Re-test as noted above...Guru...........Saaile
I’m happy to help further over the phone at https://www.6ya.com/expert/david_6df67de3b14de867
256 views
Usually answered in minutes!
×