Windows will not work. Have drivers window in down position, others up. None of them work. Believe have lock off, as have tried and nothing works. Is there a fuse, if so where located or should I check relay in fuse block and where exactly is it located?

if the fuse is for all of the windows then the drivers would not work as well
check that the other windows lock just near the drivers switch is not activated preventing other people from using the windows

On some cars when you disconnect the battery for whatever reason certain electrical areas will not be restored to operation after the battery is reconnected. You need what they refer to as a radio code to restore radio and other circuits to operation. The code should be in car manual. If not contact the dealer for the radio code for your car.

fuse 4
http://www.carpartdiagrams.com/wp-content/uploads/2012/05/Fuse-Panel-Diagram-Ford-Explorer-2000-fuse-panel.gif

hummm strange
does the master switch have a other door lock button

so central locking and windows dont work as they should

driver side window motor faulty

individual door lock actuator motors not getting power


it is possible the central locking module wont work unless reset to the other cars electronics with the correct scanner

There is a window lock button that diables all windows but the drivers window, check it.

Are you sure the window lock switch is in the "operating" position.The drivers window problem is usually a broken wire or a worn out window motor but the other windows can be made non-operational if the window lock switch is in the wrong position...if it is set correctly it may be the Body control module (in the dash behind the radio).

Before you replace anything, inspect the connector pins in both the driver's door switch and the passenger door switch. If you don't find any problem with these connector pins, replace the driver's door control switch.

First, if the driver's window is working, there is no need to waste your time looking for fuses. ALL of the windows are powered by the SAME fuse.

The first thing I recommend checking is the window "lock" switch on the master switch. If it is in the "lock" position, none of the other windows will work (it is designed to do that)

Other than that, you need to check for power and ground at all of the other door switches. The BLUE/BLACK wire at each of the switches should have battery voltage anytime the ignition switch is in the ON position. If they do not, the wire is broken between the splice near the driver's door and the right front door. Both the RED and the GREEN wires at each switch should have continuity to ground anytime the master switch is at rest with the "lock" switch in the unlock position (the lock switch breaks these grounds to "lock" the windows and prevent them from being operated).

Check the child safety locks on the rear doors and check the master window lock switch on the drivers door. If that switch is active then the window controls on the other doors are deactivated.

Hi...
Normally this happen.
when only the driver side work.
One problem could be, you have the Power window master Switch on LOCK position.
This funtion is used to prevent the Kids open the windows.
Be sure of the position of the switch or just try on both positions.
This switch is not for LOCK and UNLOCK the doors.

But if the switch is not in lock position.
Is probable to the Master switch come damaged..

But letme know if work or NOT.
I can give to you information about.
I'm a mechanic and have repair information for all the cars.

Thenk you for use fixya...