Need location of crank shaft sensor on a 1999 alero

From my Mozilla Firefox browser, I typed in, "http://www.yahoo.com." When Yahoo pulls up, just type in, "photo/drawing of 1999 Oldsmobile Alero Knock Sensor location," and press the "Enter" key on your keyboard.

You will immediately get links to 16 photos/drawings of the Alero Knock Sensor location you seek. You will also find 10 more links using words, and an "Also try" list of 10-more similar words to use in your search on Yahoo to see what else might appear.

If you want to use your regular browser, here's the link you need to paste in so you can find those same photos/drawings: https://search.yahoo.com/yhs/search?p=photo%2Fdrawing+of+1999+Oldsmobile+Alero+Knock+Sensor+location&ei=UTF-8&hspart=mozilla&hsimp=yhs-002

Best wishes!

Michael

Check that the cam shaft is turning as it may have broken a timing belt. Run fault codes to check for cam/crank position sensor problems.

THE 2.4L ENGINE CRANKSHAFT POSITION SENSOR LOCATED JUST ABOVE THE OIL FILTER.REMOVE OIL FILTER YOU WILL SEE IT.

on the 3.4 liter engine, it's behind the harmonic balancer--you have to remove the crankshaft pulley/balancer to see it.

if you have the 2.4 liter, it's just above the oil filter:

VECHICLE SPEED SENSOR LOCATED ON END TRANSMISSION AXLE SHAFT HOUSING.

ABOVE THE OIL FILTER ON THE 2.4 ENGINE AND THE 3.1 AND 3.4 ENGINE CRANKSHAFT SENSOR LOCATED BEHIND CRANKSHAFT PULLEY.

CRANK SHAFT SENSOR FOR A 2.4 ENGINE NEXT TO OIL FILTER.FOR THE 3.1 - 3.4 ENGINES CRANK SHAFT SENSOR LOCATED BEHIND CRANKSHAFT PULLEY.

Welcome to fixya. If you need anything else go to www.collisionrepairadvice.com here is the location.
On the lower rear of the engine (LA1) for the 7x
and for the 24x

On the lower rear of the engine (LA1

the crankshaft pos. sensor is just above the oil filter. take out starter and oil filter and make sure buy a new oilfilter or just make sure that you dont destroy the one on the car . remove plug and then replace with new sensor. and make sure all rubber rings if any avalable are replaced as well. then reinstall starter and oil filter and start car

on the air filter intake hose