At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
Chevy malibu recently ran out of gas ....i refuled the car and it still wouldnt crank, i noticed the radio was still on after quite some time and the engine wouldnt turnover. i replaced the battery and still no result
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
was the engine getting fuel or was their no spark ----need to establish if fuel or ignition problem ---running out of fuel may have damaged pump -deadspot -overheat ---problem with relay need to check and test the system ---
Check with the auto parts store to see what the fuel sensor looks like, It should be accessible and I have seen those go on the smaller chevys like aveo.
Look up on internet replacing gas recirculation sensor on google
Hi, you may have it flooded. Try holding the accelerator all the way down while cranking the engine to clear the gas out. Let us know if this doesn't work, and thanks for using FixYa.
Your issue is with either spark or fuel delivery and you need to check the components in each system for proper operation. Such as pump, cables, camnshaft sensor, igniter, etc.
You might want to have your fuel filter replaced. When you run a tank that low, the fuel pickup takes in debris and sediment on the bottom of the tank, which may be clogging the filter, preventing gas from flowing.
this is one way to reset it :
first make sure the battery is fully charged , then do the following:
key in the ignition but do not crank the motor, just leave it at the
ignition mode for ten minutes ,then turn it off POSITION for 5 seconds then REPEAT again 2 more times. at the 3 rd time youre gonna notice the ANTI THEFT light on dash to blink. when doing the last step , remove key , inserted again and turn on motor , good luck , AJ
×