What two sensors? When a battery is disconnected and replaced, the car needs to start and stay at idle for about 20 minutes to relearn the timing etc...only then should it be taken for another 20 minutes of normal driving on road and highway at normal speeds...this should fix the issues. Start by disconnecting and reconnect the battery leads...turn to start position without starting...leave 2minutes, turn off..wait, turn on and fully start.... leave idling awhile as above...
SOURCE: how to set timing on a 2005 suzuki reno
Here are you timing marks contact if you need more help.http://www.2carpros.com/car_repair_information/tec_info/2005/suzuki/reno/2005_suzuki_reno_timing_belt_diagram_marks.htm
Thanks for using FIX YA
SOURCE: emissons code on a 2005 suzuki reno po496
This code means the engine is getting outside air from somewhere in the system. Most of the time this code is thrown when people forget the gas cap. Or the gas cap has gone bad. on either case take the car to autozone have them clear the code maybe buy a gas cap if you didnt leave ti off and it wont give you any trouble. If the code comes back after the new gas cap then you need a new charcoul filter that mounts tot he top of the gas tank.
SOURCE: replacing the transmission range sensor Suzuki Reno
Nope, disconnect the battery before install and reconnect it when your done.
Testimonial: "Thank you so much!!"
SOURCE: 2005 suzuki reno, how do you reset check engine
leave the battery disconnected for a while, 20 min to make sure it resets the computer. If the light is still on then there in an ongoing fault that is getting tripped and turning on the check engine light. Go to an autozone or local autoparts store, they will check it and erase it for you for free.....OBDII scanners aren't cheap.
Testimonial: "thanks"
SOURCE: smells like burning oil. radiator fan not coming
you may be loseing a ground. valv coverleaking oil one time a lady had a plastic bag stuck to her muffler.pu
146 views
Usually answered in minutes!
×