I need an Illustrated Parts Break down for a 1989 GMC Sierra 1500. 350 w/ PS/PB loaded. Steering column Removal Repair or Replace

Donna, steering column wire diagram, check the attached links,instruction and guides, Good luck. "I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
http://alarmsellout.com/support/diagrams/vehicle/GMC%20SIERRA%201988-2005.pdf
Repair Guides Wiring Diagrams Wiring Diagrams AutoZone com
Wiring Diagram
1998 GMC Sierra steering column wiring diagram Google Search

You can get parts from www.rockauto.com.

Could be steering shaft on bottom of column that connects column to gearbox. Rag joint or u-joints on shaft are dry or seized. Try spraying rubber rag joint & u-joints on steering shaft with a good penetrating oil like PB Blaster. Work steering wheel all the way to left,spray, then turn all the way to right & spray some more.

sounds like sum1 had the steering wheel off. u need 2 put the spring and c clip back on rite on the steering shaft. its hard 2 do. may need 2 ppl and 2 screwdrivers 2 doit. i can 2 it by myself but its hard

replace the high/low beam switch on the bottom of the steering column, there is a rod going to it from the lever up top.

From your comments, your clutch master is no longer
working. Check your clutch master, and replace all the
worn out parts. You can buy all of these in one pack,
specify Clutch Master Repair Kit for 1989 GMC Sierra.

There is a known problem in the intermediate shaft on these trucks.If you look under the hood on the right side of engine compartment,you will see the intermediate shaft connects to steering column and runs to the steering gear.

Watch videos on youtube ( repairing loose tilt wheel)

The best thing to do is to buy a Chilton,s repair manual. It has step by step procedures. You can get one at most auto parts stores. They coast anywhere from $10-$30 dollars.

just replace the whole colmn 100.00 at junk yard and about an hours work a lot eaiser than trying too replace all those parts