Need alternator belt diagram for 1993 plymouth colt vista 2.4 l, a/c belt blown can i drive ok.

Susan; It could be one of three locations, under car along frame rial, under hood engine compartment mounted on fire wall, or under hood mounted near shock tower. below 2nd link shows the filter assembly and partial harness to help identify location.
press the helpful button

Dodge Colt Repair Manual Service Manual Online 1990 1991 1992 1993 1994

FUEL FILTER 35 VISTA CZ for 1993 PLYMOUTH COLT

How To Replace Fuel Filter

How to Change Your Fuel Filter

1 may be alternator amp is low and load is high
2 alternator main +B to battery wire resistance to high

165-185 temp is usually adequate..go with 185

1987 Plymouth Colt 1.5 liter SOHC L4 VIN "K"
or
1987 Plymouth Colt 1.6 liter Turbo DOHC L4 VIN "F"




1987 Plymouth Colt Vista 2.0 liter SOHC L4 VIN "D"




Hope this helps (remember to rate and comment this answer).

The fuel filter is under the hood, in the middle of the upper firewall, mounted in fuel line.

If fuel pressure does not increase when under load the fuel pressure regulator is bad (leaking).

Just replace I would recommend.Thanks for asking and I hope this helps out.Please leave me 4 thumbs up.

Which engine?
To replace the drive belt or serpentine belt on a Voyager check the engine size. For 2.4L engines, a serpentine belt runs the air conditioning compressor and alternator. For 3.0L models, the alternator and power steering share a belt with a separate belt for the AC. Dodge recommends checking the belts every 15,000 miles or 12 months for possible replacement. I have gone 3 yrs with one.. it will start squealing when you turn on the heater to defrost..

http://www.automd.com/46/how-to-replace-a-serpentine-belt/

Most replacement belts have a diagram on the package. However, the easiest way is to pay close attention to the belt you are taking off, and replace the new one the same way. The pulleys themselves are usually 'grooved' or 'smooth' which tells you whether the front or back of the belt is against it. The hardest part is figuring out how to release tension on the idler-pulley. If you can get the belt on and the idler/tension pulley (same thing) pulls the belt tight, chances are you got the belt right. If you don't know what I mean, then the mostest best way is to get a Clymer Manual and read up. Its really a simple thing to do yourself.

I used a long heavy duty screw driver to release the tension on a Pontiac Sunbird.. the belt will only fit on one way..

My 1993 Plymouth Colt Vista is doing something similar. It won't go into any gear - forward or reverse. It probably will need a transmission overhaul or rebuild - looking at just under $2000. Pricing online is $1380 for FWD and $1560 for AWD as of July 2010. Includes a 1 year warrantee and $300 for the core. Does not include labor; just ordering the part.

Usualy it's recomended around 80,000 to 100,000 miles, but i've seen them last up to around 200,000.
Good luck!