I have a mazda mpv 2000 minivan.problem code p0301 misfire detected cylinder#1

P0171 System Too Lean (Bank 1)
P0174 System Too Lean (Bank 2)
P0301 Cylinder #1 Misfire Detected
P0302 Cylinder #2 Misfire Detected
P0304 Cylinder #4 Misfire Detected
P0306 Cylinder #6 Misfire Detected

P1518- Intake manifold runner control fault- stuck open
p1520-intake manifold runner control fault
p0306-cylinder 6 misfire detected

good luck

P0301 Cylinder No. 1 Misfire Detected
P0302 Cylinder No. 2 Misfire Detected
P0303 Cylinder No. 3 Misfire Detected
P0304 Cylinder No. 4 Misfire Detected
P0305 Cylinder No. 5 Misfire Detected
P0306 Cylinder No. 6 Misfire Detected
P1346 Variable Valve Timing (VVT) Circuit Range/Performance Fault
P1349 Variable Valve Timing (VVT) System Malfunction
P0330 Knock Sensor
P0446 EVAP Vent Control Fault
P0430 Catalyst System

Stop driving immediately.....

You defiantly skipped on your timing........

P0301 - Cylinder 1 Misfire Detected.

Causes:
- Improper spark plug at cylinder #1
- Insufficient compression at cylinder #1
- Incorrect fuel pressure
- The injector circuit is open or shorted at cylinder #1
- Fuel injector #1 may be faulty
- Intake air leak

Solutions:
- Perform Injector Service
- Replaced Spark Plug #1
- Replaced Injector #1
- Replaced Ignition Coil #1

P0303 - Cylinder 3 Misfire Detected.
Follow info from P0301.

P0316 - Misfire Occurred In The First 1,000 Engine Revolutions.

Causes:
- Damaged CKP sensor.
- Ignition System.
- Fuel Injectors
- Running out of fuel
- Fuel Quality
- Base engine
- Damaged Powertrain Control Module

Solutions:
Usually the P0316 is combine with a P03XX codes. The P03XX code indicates in which cylinder the misfire occurred.

Generic code is Cylinder 1 misfire

CODE PO301 - CYLINDER NUMBER 1 MISFIRE DETECTED. POSSIBLE CAUSE- BAD COIL - SPARK PLUG - INTAKE MANIFOLD VACUUM LEAK - DIRTY OR FAULTY FUEL INJECTOR. CODE P1142 - DID NOT SEE. CODE P1545 - THROTTLE VALVE ACTUATOR MALFUNCTION.POSSIBLE CAUSE THROTTLE VALVE CONTROL MODULE FAULTY - THROTTLE VALVE IS DAMAGE OR DIRTY - THROTTLE VALVE MUST BE IN THE CLOSE POSITION - ACCELERATOR PEDAL OUT OF ADJUSTMENT. THROTTLE POSITION ACTUATOR IS SHORTING TO GROUND OR POWER.

Code P1399 is specific to Honda - it is an error code for "multiple variable misfires detected". P0301-P0304 are common OBDC codes for all cars, specifically "misfire in cylinder X".

You will get the P0301-P0304 codes on your OBDC reader when you plug it in (if actually errors), but will only find the P1399 if you select Honda as the manufacturer.

Just got these errors today on my CRV 2000. Now I have to figure out what is causing two of the cylinders to misfire.

P0401 Exhaust Gas Recirculation Insufficient Flow Detected

P0300 Random/Multiple Cylinder Misfire Detected
P0301 Cylinder 1 Misfire Detected
P0303 Cylinder 3 Misfire Detected
P0305 Cylinder 5 Misfire Detected


I would check out the EGR valve. That maybe what is causing all the misfires.

Here is a good site for OBD II trouble codes.  P0300: Random/Multiple Cylinder Misfires Detected, P0301: Cylinder 1 Misfire Detected, P0304: Cylinder 4 Misfire Detected.

P0300 - Engine Misfire Detected
P0301 - Cylinder 1 Misfire Detected
P0303 - Cylinder 3 Misfire Detected
P0316-Misfire detected on startup (First 1000 revolution)
You may have a coil problem or plug wires and or plugs