WHERE IS THE CRANKSHAFT SENSOR LOCATED ON A 2005 JETTA, HOW DO I CHANGE

Question edited for clarity.
Question moved to model category.

Crankshaft position sensor location - Colorado Fans

coloradofans.com https://www.coloradofans.com > threads > crankshaft-...
Dec 16, 2009 - Hey everyone.. do ya know where the crankshaft position sensor is located on our engines? It would be a big help if someone could point me ...

Crank Positioning Sensor Relearn - Colorado Fans
Oct 7, 2006
No start after replacing Camshaft Position Sensor
Mar 2, 2012
Camshaft Crankshaft sensor ' Chevy Colorado & GMC Canyon
Feb 22, 2015
Colorado won't start after replacing the Camshaft Actuator ...
Sep 11, 2012
More results from www.coloradofans.com
..

Hi Rusty, There's two links below showing the position of 2005 Ford Explorer Crankshaft Position Sensor and the 2008 ford edge camshaft sensor location. It seems like they're all in the same position, I hope this helps.....CHEERS
..
2005 Ford Explorer Crankshaft Position Sensor Location

2008 ford edge camshaft sensor location

The ect sensor is the coolant temperature sensor depending what engine you have this video should be more or less the same if not look toward the top hose that goes to the engine

http://m.youtube.com/watch?v=wLbpoju7Wis

The crankshaft position sensor mounts to the engine block behind the alternator near the oil filter.

located on the inner side,like bmw,on the flywheel support area,
just outside of the oil seal,

P0315 - Crankshaft Position System Variation Not Learned
P0335 - Magnetic Crankshaft Position Sensor Electrical Error China OBD2 car diagnostic tools wholesale on CareUCar

Here's a link to your sensor. 2005 Nissan Datsun Maxima crankshaft position location Google Search Need a 10 mm wrench to remove.

camshaft sensor located above crankshaft pulley, the camshaft sensor mounted on the front timing cover above the crankshaft pulley.

REMOVAL - 2.0, 2.4, 2.4L TURBO
The Crankshaft Position Sensor is in the front of the engine block just under the starter motor (CRANKSHAFT POSITION SENSOR LOCATION).

Disconnect the negative battery cable.
Raise vehicle and support.
On 2.4L SRT-4 remove the lower inner cooler hose from the metal tube.
Remove the Structural Collar (Structural Collar and Bending Strut-(Automatic Transaxle Equipped) ), refer to the Engine, Structural Collar Removal and Installation section.
Unlock and disconnect the electrical connector to the crankshaft position sensor.
Remove the crankshaft position sensor bolt.
Remove the sensor. Arrow points to sensor in picture.

1996 Volkswagen Jetta 2.0L SFI 4cyl
The Camshaft Position Sensor is located under hood, center, upper engine area, driver side of engine block, mounted in distributor.

This sensor performs the same function as a crankshaft position sensor; providing a signal to the ECM regarding the position of the crankshaft.

Although the camshaft position sensor is an essential input for the ECM to determine ignition timing, information on testing the sensor is located in of this guide (autozone.com / free register).

Hope help you; remember rated this help. Good luck.