Where is the rear bank camshaft position sensor located on a 2004 Nissan Maxima DOHC 6 cylinder?

Question edited for clarity.
Question moved to model category.

One on each bank

Camshaft position sensor - Engine & Transmission

Dodge Journey Forum https://www.dodgejourneyforum.com > topic > 5405-...
Feb 21, 2014 - The Camshaft Position (CMP) sensors are located at the rear of the cylinder head covers and are bolted to the cylinder head. Disconnect and ...

3.5L Camshaft position sensor - Dodge Journey Forum
6 posts
Feb 23, 2017
Crankshaft position sensor - Electrical, Battery & Charging
8 posts
Jul 1, 2016
Camshaft position sensor bank 1 - Dodge Journey Forum
3 posts
May 4, 2020
2014 Dodge Journey Cramshaft and Crankshaft Sensor
7 posts
Jan 4, 2018
More results from www.dodgejourneyforum.com ..

Question edited for clarity.
Question moved to model category.

The 2007 Nissan Maxima Camshaft Position Sensor Bank 1 Location is located on the top right side of the engine, near the firewall. It is in line with cylinder number 1, and it will be found between two spark plugs.

Where Is The Camshaft Position Sensor Located On A 2007 ...

Here's a link showing you your camshaft sensor locations. Where is bank 2 located for the camshaft position sensor on 2004 nissan...

I am not sure what "slip n tcs" means but on the 2005 nissan maxima the code P0340 is for the camshaft position sensor circit on bank 1, which is in the rear of the engine compartment. Code P0345 is for camshaft position on bank 2, which is in the front of the engine compartment. The images show the Cyl banks and a cam sensor.

This engine has two camshaft sensors located on the cylinder head side( on the air intake side).

2002 Nissan Maxima 3.5 liter 24-Valve DOHC V-6




Hope this helps (remember to rate and comment this free answer).

bank two is the bank of cylinders that is closer to the radiator...not the firewall side.

3.5litre V6 Front wheel drive, the cam position sensor is in the back of the cylinder head above the transmission. bank one is the front bank, nearest to the grill. the cam sensor is held into the head with a 10mm bolt, has one wireing connector with 3 wires in it. the sensor is sort of round with a leg off one side for the bolt the secure.
may need to remove the engine cover to see it. it is held down with allen key bolts.

There are 2 on this vehicle one on eitherside of engine. Left and right or bank 1 and bank 2 Consider taking it in for correct diagnosis.

Should located on the rear cylinder head near the throttle body.