1999 Mazda 626 Logo
Anonymous Posted on Aug 09, 2011

Mazda starter switch in park Car starts in neutral, but won't turn the starter in park. Battery is fine, its a1999 6cyl with automatic. Intermitent problem

1 Answer

Anonymous

Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

  • Master 4,803 Answers
  • Posted on Aug 09, 2011
Anonymous
Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Joined: Oct 10, 2009
Answers
4803
Questions
0
Helped
2962454
Points
18833

You need to replace and adjust your transmission range sensor switch. (also known as neutral safety switch) It is located under the air cleaner ducting on the top of the transmission under the lever where the shifter cable attaches.

×

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers

2003 voyager lx, won’t turn over, starts when it feels like it, changed starter, starter relay, and ignition switch nothing helps.

Automatic has a shifter switch to assure you're in park or neutral. Clutch on stick shift has a switch too.
2helpful
4answers

2009 chevy malibu won't crank.. Changed battery,

Did you ever figure out the problem Jason? I have the same exact deal going on with my 09 Malibu I can't figure out what the deal is?
1helpful
2answers

My car runs fine for days then i'll park somewhere and go to turn it back on and it won't start at all. It won't turn over or anything.

CHECK BATTERY CONNECTIONS, STARTER CONNECTIONS, WHAT DO YOU DO WHEN IT DOESN'T START, TO GET IT GOING AGAIN, DO YOU GET A JUMP START IF SO CHECK CONNECTIONS.
0helpful
1answer

1998 Honda Accord Won't Start

Park neutral safety switch maybe be the reason for the no crank ! Try putting the vehicle in park ,then try to crank the engine . Testing the electrical circuit is the best way to trouble shoot this problem , along with do a voltage drop test on the starter circuit ! This will test the battery cables an connections .
Starter Voltage Drop
How to voltage drop test starter motor circuit
Does it have a manual or automatic transmission ? Manual ? clutch switch . Looking at a wiring diagram I also see a starter cut relay !
http://www.bbbind.com/free_tsb.html Free wiring diagrams . Enter vehicle info. year , make , model and engine size . Under system click engine , under subsystem click starting . Then click the search button , then click the blue link ! Check the starter cut relay also . Videos on youtube showing how to test a relay controlled circuit !

1helpful
1answer

Turn key on, but doesnt even click. battery and starter are fine

This may be due to a bad neutral safety switch, is this car automatic or manual transmission?

If automatic try to start in neutral and if manual try to locate switch on clutch pedal and use a jumper wire to jump connector for switch, NOTE; If switch is jumped car will start in gear with pedal not pushed down and car will take off so this is just as a test not a repair!!!!!, good day
0helpful
1answer

My 1985 Ford Laser automatic won't start in Park or Neutral

you may mean a plymouth laser but any how it sounds like it needs a new or neutral saftey switch or an ajustment of this switch which is located on the ******
0helpful
1answer

97 Maxda Protege starter engages automaticly in park or neutral with key in ON position

You've pretty much answered your own question, although I doubt it's demons...LOL. Ign switch, nuetral safety or park switch, shorted starter, could be chaffed wiring. If your in the ON position and the starter engages, I'd be looking at the ign wire from the switch to the starter solenoid and or relay. Your car is 20 years old so anything is possible at this point. Your best bet is to go to ALLDATA>COM and buy the wiring schematics for your car grab a DVM and start checking your circuits.
0helpful
1answer

Grand Am 4cyl was fine tried to leave after a sjprt time ;ater starter didn't clich or make any noise battery checks 12.6 volts what's wrong?

Check connections at the battery and the starter. Check fuses. Ensure the vehicle is in park(automatic trans) or neutral(manual trans). If you're still having the problem, try starting in neutral-if it starts; possible shifter cable misadjustment, or faulty neutral safety switch. If the starter is hot afer attempting, suspect faulty starter.
6helpful
3answers

2002 mazda protege 5 will not start - will not turn over, starter is fine, battery is new, power is going to the starter, everything is clean, is in park or neutral, no clicking sound at all, fuses are...

Help please....I have Mazda Protege 2002...the car was driving good..and suddenly the car didn't start at all i changed the starter the battery is fine because when i start the car the lights comes on and the radio works. I don't know what is the problem is...when i start the car it makes noise of tik tik. Please help me????
Not finding what you are looking for?

719 views

Ask a Question

Usually answered in minutes!

Top Mazda Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...