There seems a distinct possibility your suspicion is well founded...
Fluid quantity is usually quite small so a small leak will soon result in a drop in the level. It isn't unusual for a steering rack to appear wet and oily from a "sweat" or two without actually leaking and there might even be a drop or two of fluid gathered there but it should be obvious to an experienced mechanic what is a leak and what can be ignored.
It is possibly a coincidence and the rack began leaking suddenly during the test but such a leak would be obvious by a fairly constant dripping and a clearly visible oozing of fresh fluid.
The presence of a serious long-term leak is indicated by a distinct lack of road dirt around and below the leak site as the constant flow will wash it clean - and of course the reservoir will need regular topping up.
There seems a distinct possibility your suspicion is well founded...
Fluid quantity is usually quite small so a small leak will soon result in a drop in the level. It isn't unusual for a steering rack to appear wet and oily from a "sweat" or two without actually leaking and there might even be a drop or two of fluid gathered there but it should be obvious to an experienced mechanic what is a leak and what can be ignored.
It is possibly a coincidence and the rack began leaking suddenly during the test but such a leak would be obvious by a fairly constant dripping and a clearly visible oozing of fresh fluid.
The presence of a serious long-term leak is indicated by a distinct lack of road dirt around and below the leak site as the constant flow will wash it clean - and of course the reservoir will need regular topping up.
I suggest you wash the area around the "leak" and retest it.
×
SOURCE: power steering fluid leak
check the lines to the rack and pinion,,,,cpild have a ruptured line
SOURCE: 2003 Jeep Liberty heater fan problem
It is the blower motor resistor. Look under the passanger side dash and locate the fan housing (looks round and black in color. Then locate the resistor it will be in that housing usually withtwo ten millimeter nuts or two simple screws holding it in. unplug the harness to the resistor and remove the resistor. Part store price is approx. 50.00. Note: on aftermarket (not Jeep) resistor sometimes you have to modify the housing a little to get it in. Hope this helps.
SOURCE: How to replace reak brake rotors on Jeep Liberty
Replace rear rotors on 04 liberty.
Remove tire & wheel
Remove brake caliper, tie up out of way.
Back off e-brake shoe adjustment.
Remove factory spring clip from lugs (2places)
This is the crude part....
After attempting to pull off disc/drum with puller....I got pretty sick of it. Understand this is in the Northeast with lots of salt on the roads in winter. Needless to say there is a ridge of rust around the inside edge of the e-brake surface. Any more pressure and I was afraid of damage to the e-brake shoe asembly. I then took a small grinder with a cut off wheel and cut the disc thru (used space where caliper usually sits). Also cut nearly through the face between 2 lugs. You can't quite get thru the back corner at the disc. Since the material is cast iron it will crack when you drive a wedge in the slot cut in the disc. This opens the housing around the shoes and it slides off easily. The cutting operation took less than10 mins, alot less than the puller with hammer assist!
I know this is a bit "unorthodox" to say the least, however the object is to remove the old junk disc safely and as quickly as possible, without harming the e-brake parts inside.
Install new parts in reverse order, new pads go in easy after squeezing the caliper piston back with a c clamp as is the normal procedure.
SOURCE: 2004 jeep liberty thermostat change?
ihave to change my thermostat in my 04 jeep liberty is it hard
SOURCE: rack and pinion removal and installation
it is sort of a strange deal but you have to remove the cowl and the wiper assembly and access it through there. You can get the step by step instructions from autozone
77 views
Usually answered in minutes!
×