Engine model 4 M 40 timing marks

Would need to see type of engine and a good look ,does it have any marks on front of engine ? if not then crank mark will be through a hole in bellhousing ,injector pump if common rail will have no marks as not needed to be timed in ,camshaft if no holie in spoke on gearwheel tand no mark on rim then remove the rocker cover and look on back of camshaft for a slot ?but no year mentioned here so ?? why didnt you put some white paint marks on gears before you took it apart

Pajero 4M40 fuel pump timing out? - YouTube

? 2:03
https://www.youtube.com/watch?v=wYwe7NGniuA
Jun 28, 2014 - Uploaded by fsaroyster
?????(??????)???? MITSUBISHI CANTER 3.5T 2.8L 1998~ 4M40 TURBO M015S5 - Duration ...

Fuel pump removal 2.8 fuel pump seal replacement - Forum

pajero.myfreeforum.org/.../fuel-pump-removal-2.8-fuel-pump-seal-repla...

2 posts - ‎1 author
Fuel pump removal 2.8 fuel pump seal replacement ( Courtesy of R.Ambrose ) Tools and stuff ... My pump number is 104741-3211 ('93 Lwb, Eng 4M40) The drive ... Very carefully undo the nut on the earth terminal by No.1 injector. ... Mark a tooth and the housing (tipex) to ensure the fuel pump is fitted back the same way.

HELP!!!!! please 4M40 issues - Mitsubishi Pajero and Shogun Owners ...

www.pocuk.com/forums/wap/thread.php?topic_id=115551

Sep 23, 2010 - We are a domestic diesel shop in alberta canada and do not deal with ... I rechecked all timing marks several times so I pull injection pump and ...

[PDF]ENGINE Workshop Manual 4M41 - MitsubishiLinks.com

www.mitsubishilinks.com/.../pajero_fsm_printed-2000_engine_4m41-32...

Most engines are required to be a TDC or Top Dead Center and then align the timing mark on the injector pump with the housing or mounting surface mark. I would obtain a specific manual for your engine...just to make sure. Best Wishes.

There is a timing light made for diesel engines works on the injector pulse and TDC mark . best bet take it to diesel service workshop, or buy one, not cheap.

We are a US based wesite and we have no diesels here in this model or make.

There is a special tool to put back the injection pump. MH063302 OR IT EQUIVALENT. On crankshaft gear mark 1, on idler gear mark 11 to match them. watch the timing chain marked and idler marking.

How to set the injector pump timming?

install pump install gear on pump line timing marke on gear with timing mark on front back plate

This engine has a timing belt.Once you have removed the engine front cover , turn the engine to the marks as shown in the diagram.Lock the crankshaft in this position with an old reverse light switch from the gearbox by inserting it into the hole under the bell housing (manual transmission).Before removing the belt , loosen 3 bolts on the injector pump after you locked this with a 8.5 mm drill bit.Replace the belt and pull the tensioner to 16 Nm.If you are fitting a whole pulley replacement kit take note of the upgraded spacers and their position.Dont forget to tighten the injector pump bolts again after you tensioned the belt and recheck your timing marks.