SsangYong Cars & Trucks - Recent Questions, Troubleshooting & Support

TORQUE SETTING FOR CYLINDER HEAD ON SSANGYONG KORANDO 2.9TD

You have a power drain or an electrical short somewhere on the vehicle. There might also be an issue with the alternator not charging the battery correctly. Check the basics first. sometimes the repair can be that easy. Take a good look at the battery and the wires connected to it. Look for damage to the battery, worn or damage to the actual wires. Check the clamps connecting the wires to the battery are clean and tight. Only touch one at a time that way you don't get an electric shock. Also make sure the battery is clamped down correctly as if it is moving around it can cause issues. Hunting electrical issues is a pain in the tailbone job so I would suggest if you don't know vehicle electrics that you get a good mechanic or an Auto Electrician to look at it. Without seeing and examining the vehicle most suggested repairs would be based on guess work.

I'd say you either have the manual switch in the ON position or a bad door switch

Probably the core plug has failed.

Question edited to fix the formatting and lack of spaces between words. Find a local auto auto electrician and connect it to a professional grade scan tool computer. The reason for the limp mode will be stated as codes. The codes tell you the fix. I expect the dealer knows that as a cheaply made Korean car the best fix is to just buy a new one. They are really a disposable commodity at 8 years old. https://www.google.com/search?q=auto+electrician+near+me ..

You may have a bad connection in the clock spring if it is the airbag in the steering wheel. They are dangerous to work on. https://www.google.com/search?q=2016+ssangyong+rexton+air+bag+light+stays+on ..

Needing diagram for terpentine belt configuration for 2012 ssangyong rx270 turbo diesel

you broke it the wire inside the door are not broken so just look every where you touched and bingo the problem seen. or blew a fuse next time doing any electric work on the car pull the battery neg lug. to prevent damage to the car. if confused and lack a service manual to test the wiring go to a shop and have them look.

lost the users guide? read it? none here USa,. no books , no part yes UK yes Australia, no country told and lighting on cars is 100% regulated by your country. even auto leveling lamps. yah complex max. no country told no year no books to SHARE.

Hi i have rexton 2008 used to have a problem with 4wd check light. 4wd check light course faulty vacuum pressure velve.thee valve is located between the front left light and the battery,is mounted under the battery stand. Got two small pipes going to the gear box.

is this first car in winter, is it winter there.? do other cars smoke there cold days outside. smokes only cold so is normal (stream) or EFI is too rich diesel. normal is steam, not smoke, oil.

There are several possible reasons why a 2006 Ssangyong Musso with a diesel engine might not start, even if the engine is cranking over. Some possible causes could include:

1. A problem with the fuel system, such as a clogged fuel filter or a malfunctioning fuel pump
2. A problem with the ignition system, such as a faulty spark plug or a malfunctioning ignition coil
3. A problem with the engine itself, such as a seized piston or a damaged cylinder head
4. A problem with the electrical system, such as a dead battery or a faulty starter motor

To diagnose the problem and determine the necessary repairs, it is best to have a mechanic inspect the car and perform any necessary tests. They may need to check the condition of the fuel system, the ignition system, the engine, and the electrical system, and they may use diagnostic equipment to read any fault codes stored in the car's computer system. Based on the results of the inspection and testing, the mechanic should be able to determine the cause of the problem and recommend the appropriate repairs.

hi guys my rx has same problem there sometimes light on ABS ESP HDC also EPB what should i do now ?

any car parts store sells them all do. in your country. not told

Check what the code is, that will give you a good idea what the issue is.

read the users guide in the glove box if lost it? get one from the car maker or dealer in town. or google for it.

bad starter,if starter spins fast and crankshaft does not/ ive fixed my of the just cleaning pinion shaft. even back to 60's to be honest I can't hear and if did would yes for sure bla bla.

Hi ihad the problem the remote stopped working ,My car ssangyong rexton 2.9 with bosch inline injector pump, My car was parked in such a position it could not be moved, I located the imobiliser which was fitted to the injector pump with a bolt that when tightened sheered the head off ,I removed the fuel pipe fitted to it got s sharp small chisel and a dot punch ,The bolt head is dome shaped Attacked the head with the chisel and then the dot punch,The bolt came loose undid it with my fingers, took it off the pump removed the encoder unit soldered 2 wires to the sllenoid no more imobiliser just feed solinoid with 12v from ignition ,Weld new head on bolt Job done

Hi, This indicates a problem with the "Camshaft Position Sensor A circuit", so please check that or you can take it to a local mechanic for help with fixing the issue. Thank you.

same problem any answers