Seat Cars & Trucks - Page 2 - Recent Questions, Troubleshooting & Support
Have a 2006 Mercedes ml500 both seat won't go forward or back
- Check the fuses: A blown fuse could be the cause of the problem. Check the fuses related to the power seats and replace any that are blown.
- Check the wiring: There may be loose or damaged wiring in the power seat system. Inspect the wiring and connections for any damage or looseness and repair or replace as needed.
- Check the seat motor: The seat motor may be burned out or malfunctioning. Have the motor tested and replace if necessary.
- Check the control switch: The control switch could be faulty. Check the switch for any damage or issues and replace if necessary.
- Take the car to a mechanic: If you are not comfortable or experienced with car repairs, it is recommended to take the car to a mechanic who is familiar with Mercedes-Benz models, as they may be better equipped to diagnose and fix the issue.
My 2010 camaro driver seat is stuck in recline. I've seen others say theirs are stuck forward, but I seem to be the only one with it stuck in recline. All other seat features work. (minus seat warmer)
http://ibb.co/jmpRRc
Click on the link. I'd have to check the recline seat motor wiring circuits, You can see the wire colors in diagram, voltage and ground. The voltage and ground circuits switch depending on direction, up or down.
You could remove seat motor, use jumper wires off your battery for voltage and ground, you would reverse the wires depending on direction, You probably should use an inline fuse, just in case. If the motor only operates in one direction of nor at all, have to suspect the motor. That is a no load test. If the motor works both ways, I'd have to check mechanical linkages or gears that the motor uses, to see if anything broken?
How do you fix a wobbly seat?
i hit it with a wobbly hammer hard
no car told , maker make, or year.
we can not see your car. or truck./
is this GYM toy? post to GYM not cars.
How do you get the back seat out of 91 leberon convertable
Chrysler Le Baron? with an A.
the whole thing out. all of it.
most seats simply bolt to the chassis floor metal;.
some have plastic things there hiding the ugly there and simply snap off.
32 year old paper manual are not easy to find but are found used on ebay. buy one? but users guide really it does not cover this job only the s SM does below.
service manual states, 1991
- To remove the rear seat cushion, perform the following:
- Remove the bolts holding the cushion to the floor.
- Push the center occupant seat belts through the openings in the cushion.
- Remove the cushion from the vehicle.
- Remove the seat back by performing the following:
- Hinge the seat back forward and disengage the push-in fasteners holding the carpet backing to the trunk floor.
- Remove the bolts holding the outboard hinge pivot bracket to the seat back.
- Pull the seat back outward to disengage the inboard pivot and remove it from the vehicle.
Is there access to the fuel pump behind the front seat on a mazda6 2004 and which side driver or passenger
no engine told. 2.3L and 3.0l here.USA car? answer are USA only ! you could look under any car to see if the body does have breach there. for pump access. (hatch) i post the service manual words to you. 1. Complete the "BEFORE REPAIR PROCEDURE". ( release fuel line pressure steps as we do on all EFI cars. 2. Disconnect the negative battery cable. 3. Remove the rear seat cushion. 4. Remove in the order indicated in the table.
2017 chevy 1500 drivers seat only reclines snd raises on one side.
It is possible that there could be a way to repair the driver's seat in your 2017 Chevy 1500, but it depends on the specific issue that is causing the problem.
If the seat frame is damaged, it may be difficult to repair and a replacement seat frame may be necessary. However, if the issue is with the motor or mechanism that controls the recline and height adjustment on one side of the seat, it may be possible to repair or replace that specific component.
You may want to consider consulting with an independent mechanic or auto upholstery specialist to get a second opinion and explore your repair options. They may be able to diagnose the issue and suggest a more cost-effective solution than replacing the entire seat frame. Additionally, searching for used parts at auto wreckers or online marketplaces could also be a more affordable option.
2010 seat ibiza 1.6 tdi ,I've had my dpf cleaned ,now the dpf filter light comes on every couple of weeks ,any ideas what this could be
Potential causes for the DPF light coming back on in a 2010 Seat Ibiza 1.6 TDI after cleaning are:
- DPF re-clogging - If the DPF is not properly regenerating, it can re-clog and trigger the light.
- Sensor malfunction - The sensors monitoring the DPF and exhaust system may be faulty, causing the light to come back on.
- Software problem - A software issue could trigger the DPF light even if the DPF is functioning normally.
- DPF damage - The DPF may have been damaged during the cleaning process, requiring replacement.
It's advisable to have a professional diagnose the issue using specialized diagnostic equipment. A qualified technician can determine the root cause of the recurring DPF light.
Not finding what you are looking for?