Scion Cars & Trucks - Page 9 - Recent Questions, Troubleshooting & Support

http://www.installer.com/pdf/99-8209.pdf

You need to disconnect the battery and then go under the car and unbolt the starter wiring and then unbolt the starter from the transmission bell housing.

try this article. Its pretty simple.

http://scionlife.com/forums/showthread.php?t=16364

There is no maintenance to do on that auto transmission. All that is suggested is a drain and fill, or power flush, at 100-120k miles.

the automatic scion xa is only 4 speed .. My standard scion is 5-speed and its always begging for 5th gear after 65mph+

You need to open the air/filter box, not remove the hose.

just the mirror or the entire housing ???

just mirror

• remove old mirror (pry out)
  
• unscrew from holder
• screw new mirror into holder
• press holder back into housing

entire housing

• open door
• pry off mirror shield (might need to unscrew) the shield is inside the door which hides the bolts holding the housing
• unscrew housing
  
• remove power cable (if any)
• plug in cable to new housing (if any)
• bolt the new housing in place
• replace shield.
  

Email Chris Bacon here: www.autolumination.com*License Plate Light Bulb Size: 168I buy all of my bulbs there.

could be loose wheel nuts take the car to a specialist brake shop for a pad/rotor /drum inspection

i have the same experience.please check for crack or brooken plate under chases that holds the shaft of the steering wheel. it happens to my car too.

Check all ground wires and make sure they are tight. Start at the battery, starter, solenoid switch.

no, first manufacture has tested and the tires that came with the car is the correct size, by adding a different tire, could cause lots of problems

change your serpentine belt. Try a Goodyear gaterback belt.

First of all let me give u the exact specs of tires of ur scion xd.
Front Tire Size P195/60HR16.0 BSW AS Rear Tire Size P195/60HR16.0 BSW AS Front Wheel Size (in) 16′ black steel Rear Wheel Size (in) 16′ black steelTo purchase please refer amazon or ebay.

There are many things that can cause that, from a bad strut to a bent wheel even an imbalaced tire, tire balancing is cheap $10/ tire, that is where i would start

MIKE

it can be low tire pressure or you just need an arlinement

the correct size of tire is listed on the drivers side door frame

Check the heater flaps for operation, you may need to dive into the footwell with your head under the dash to do this. The option is the heater matrix is blocked. There is no real solution to this, only replacement. Or there has been air introduced to the water system and has airlocked the heater. If you don't know how to clear it, find a local mechanic or good DIYer. If you replace the coolant make sure there is sufficient antifreeze because water only corrodes the system and blocks the rads.

dont thinc he did it rite--there are 2 nozels on the system-------go to a parts store and ask for assistence before heat stroke

Your intake air temperature sensor is part of the MAF (mass airflow sensor) and located right off the air filter housing in the large tube going to the throttle body.Its held on with 2 screws and has a 5 wire electrical plug going to it.