Tip & How-To about Ford Explorer
One picture is worth a thousand words ,well here is how to bypass the explorer bosch built in factory alarm .Fist you have to drill the the immobilisor out or the bodywork its situated at the back drivers side LHD vehicles behind the back seat above the wheel arch behind all the paneling .Once you have found it then disconnect it first and then drill the rivits out that hold it all in place ,then under the plastic box is three screws that hold the case together ,then you will have to solder the earth connection to all the points as in the photograph and it will start ,Well it should but the one iam working on at the moment is still not getting fuel so i may have to hotwire the fuel pump direct but at the moment iam still working on the vehicle but the dark defeated me .Anyway as and when i sort the fuel pump out i will modify this tip although it could be the fuel cut off switch caused by the journey on the breakdown truck.So iam not entirely sure but i do have it turning over and a nice spark so iam almost their i think and another hour or so tomorrow i will have it sorted somehow or someway .Well i found out how to get the fuel pump to work you have to drop the fuel tank ond on top of the pump is a frequency controlled switch with 4 wires running to it ,cut the two bigger wires and join then together and then it will fire up this frequency switch doesnt allow the power through till it gets the right signal from the alarm unit so joining the tow wires together defeats it ,leave the thin wires in place they dont need touching -
2,542 views
Usually answered in minutes!
×