Acura How To Restore Electric Window One Touch Control

the battery is no longer good and can no longer hold its charge, example, u need to boost ur car in the morning but then ur fine through out the day, car sits over night thus loosing its charge and needs to be boosted again

If your vehicle is equipped with the "Express-Up" feature, the door module probably lost its calibration when the battery was disconnected. To recalibrate this feature, roll the windows all the way down. Then hold the button to the up position. Continue to hold the button up for two seconds after the window has reached the full up position. Roll the window down again and repeat this a second time. The express-up feature should now work for that window. Repeat this procedure for the other front window.
NOTE: the REAR windows are NOT EQUIPPED with this feature.

Hi,
Hi!!

Here is a little information on how window regulator works. Also step by step instruccions on how to remove and install the window glass.

Door Glass & Regulator Power Windows
Diagnosis & Testing
When the rear window lockout feature is enabled, the circuit is open and no voltage is supplied to the rear window switches. When the feature is not enabled, the circuit is connected to battery positive voltage. If this circuit is shorted to ground when the lockout feature is not enabled, the PWR WDO circuit breaker may cycle continuously OFF/ON until, either the lockout switch is pressed to open the circuit, or the circuit breaker is permanently damaged. All windows may be partially or totally inoperative while the fault is present.
Inspect for aftermarket devices which could affect the operation of the system. Inspect the easily accessible or visible system components for obvious damage or conditions which could cause the symptom. Faulty electrical connections or wiring may be the cause of intermittent conditions.
Removal & Installation
Window Motor & Regulator

1. Position window approximately half way down in the door.
2. Remove the interior trim panel.
3. Remove the water deflector.
4. Tape the window to door frame to prevent it from moving.
5. Remove the three front door window regulator motor screws.
6. Disconnect the electrical connector from the window regulator motor.
7. Remove front side door window regulator motor.
8. To install, reverse removal procedure.

Window Switch
Front

1. Remove the front door pull cup screws and pull cup from the front door trim panel.
2. Disconnect the electrical connectors from the front door power window control switch.
3. Remove the front door window control switch using a small, flat-bladed tool at the side of the switch.
4. To install, reverse removal procedure.

Rear

1. Remove the rear door pull cup from the rear door trim panel.
2. Disconnect the electrical connectors from the power window control switch.
3. Remove the rear door window control switch from the pull cup using a small, flat-bladed tool at the side of the power window control switch to release the power window control switch retainer.
4. Remove the power window control switch from the rear door pull cup.
5. To install, reverse removal procedure.

I'm not certain of the layout of the bolts on your particular model, but there should be 4 bolts, one at each end of the seat tracks (the things the seat slides back and forth on), attaching the tracks to the floor. You may need to slide the seat back to access the front bolts, and forward again to get the back ones. Tilt the seat back right forward to allow you to get the seat out the door. If the seat has electric controls there will be some plugs to disconnect under it. If there are any yellow coloured plugs, DO NOT disconnect them without disconnecting the negative terminal off the battery and waiting for 5 minutes. The yellow plug is an airbag system plug, and if the battery is not disconnected the airbags could potentially deploy. Make sure the battery remains disconnected for the entire time that the yellow plug is disconnected, and reconnect the battery AFTER the yellow plug. If there isn't a yellow plug, don't worry.

Hope this helps.