Where is the turn signal relay located on a toyota camry

I think its in the near the fuse box, on mine I have to remove the glove box liner to access it, its a small round thing with either 2 or 3 prongs on it

Hazard and Turn Signal Flasher Replacement
Open the glove box to expose the glove box retaining tab (1). Lift the retaining tab and allow the glove box to hang freely.
Using a suitable flat-bladed tool, release the plastic retainer that retains the hazard/ turn signal flasher (1) to the C203 body harness connector (2) . Remove the hazard/ turn signal flasher (1).

Turn signal flasher is normaly located in the fuse panel. It should be round and have three prongs If I remember right. there might be two of them, one for signal and one for hazard.

Hi,

It is located in the relay box behind the lower dash under the steering wheel, in alignment with drivers right knee. (right hand drive) You have to remove the screws that hold the panel on and take panel right off. If you remove fuse box cover, look behind and you can see them. Fuse box cover is on the end of the dash board. Hope this helps

I'm answering my own question here. It's located behind the hazard lights switch. You have to pop out the old one with a flathead screw driver. Remove it and simply place the new one on. You might need some needle nose plires to pull the actual relay out and also to pull out the connecting end. You might have to play with it for a lil while but it should come completely out. If you still have a hard time just take out the glove box and reach around the tight spots until you reel for thr cords on the connecting end. I did all this in about 30 minutes and saved a lil over 100 dollars. The relay itself cost about 26 dollars at the vw dealership.

The flasher is a small round plastic cylinder (unless replaced with a metal one) behind the left edge of the glove box that will look similar to the one in the fuse panel. The first step is to squeeze gently both sides of the open glove box and let it swing downward. It will be snapped into a metal horizontal brace just to the left of the glovebox opening by a small tab and have two wires attached. The number more than likely will be a #552 although I have seen a factory one with a Warner #224