Tip & How-To about 2005 Toyota Matrix

Verso semi auto box .

After repair/replacing of bearings/seals when fitting gearbox housing to bell housing put a wedge between casing and bell housing to keep both ends apart this will stop gap closing when you lie it on its side and stop the magnet falling out you will also be able to tighten two 12mm bolts for gear slider,through this gap it is very easy to put sealant in place once you know the box is lined up,and doing it this way you dont disturb sealing surfaces until you are are actually ready to push both ends together .

Posted by on

2005 Toyota Matrix Logo

Related Topics:

Related Questions:

1 Answer

so if its leaking fluid does that mean i need to replace transmission


It depends on what fluid and where abouts in the transmission its coming from. If its coming from the bell housing end it might be engine oil from the crank shaft seal inside the bell housing in which case you will be loosing engine oil and not transmission oil - gearbox off and replace the seal. If its coming from a plug or seam on the transmission then it probably wants a re build to cure it but a local garage should be consulted before spending any money.

Nov 22, 2017 | Cars & Trucks

3 Answers

Why would I have oil in where my flywheel is and


Give more information. What car, what year model? If there is oil where the flywheel is, chances are you have a leaking rear main bearing oil seal or leaking gear box primary shaft oil seal. Coil packs? They should be there to make the car go.

Sep 27, 2014 | Cars & Trucks

2 Answers

how to replace the bell housing of a 1989 jeep wrangler 4-cyl 4x4?


why are you replacing the bellhousing?,it means you are going to have to pull out the motor or the gearbox/transfer case,whichever is easieast

Jul 04, 2014 | 1989 Jeep Wrangler

1 Answer

2003 passat 130bhp tdi auto. oil leaking fromtork converter the car recently had a gearbox oil and filter change and drove perfectley but when i put it into reverse and drove it for about 50 meters all the oil came out through the bell houseing what do i need to do to fix it any help will be greatfully accepted


Hi Craig,
I'd suggest that the oil seal which seals between the torque converter neck and the gear box casing is damaged and will need replacing. The job seems simple but in fact can result in breaking the gearbox oil pump, when the torque converter is refitted to the gear box. the neck has to align with the gears inside the gear box and the oil pump, if the torque converter is not fitted correctly the damage I've mentioned will take place when refitting box.
If you would like to proceed let me know.
Regards Johngee10

Mar 02, 2011 | 2004 Volkswagen Passat

1 Answer

how to take golf gearbox apart


There is a cover on the back of the gearbox, Remove the cover and wedge 5th gear and reverse off the shaft. One that is done you must remove all the bolts around the bell housing. It might be that the 2 casings stick to each other because of the sealer used to seal the gearbox. The casings should slide off once the sealer has lifted.

Sep 12, 2009 | 1994 Volkswagen Jetta

Not finding what you are looking for?

1,743 people viewed this tip

Ask a Question

Usually answered in minutes!

Top Toyota Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Loading...