Plymouth Sundance - Answered Questions & Fixed Issues


The blower motor resistor is located in the same duct that the blower motor blows through. If you see the blower motor, within a foot of it is the resistor. The blower motor actually blows over the resistor to keep it cool. The blower motor is usually only in 1 of 2 different locations. On passenger side, access under the hood or under dash access behind glovebox. In both cases the resitor will be in the duct that the blower motor blows through.

1994 Plymouth... | Answered on Aug 30, 2018 | 480 views


The problem will be some where between the road wheels and the suspension mounts on the chassis. Here's a check list to try.
-Wheel rims. Balanced doesn't mean straight.
-Loose wheel bolts.
-Brake discs for warping, Pads for wear and calipers for sticky pistons or loose fit
-Hubs and bearings for wear.
-Ball joints for wear.
-Suspension mounts, top and bottom.
-Suspension swing arms at both ends.
Do this for the front AND the rear of the car.
If none of these are the issue you might have to get the drive shafts and transmission checked.

1994 Plymouth... | Answered on Mar 03, 2018 | 125 views


Sounds like a blown globe check the globe on the blinker that is not working it will probably be black or if you have good eyes you may see that the little wires that connect the two little prongs inside the globe are broken.
Hard to see so as they are only a couple of dollars best just replace the globe on the one that is not working.
To access you may need a Philips head screw driver to take the cover off.
Or it may require the globe case may need to be turned from the inside.
If you are not shore how to get it of take it to a place like a auto shop they will probably change it for you
This is most likely the problem.
Let me know if this fixes it.
Regards Craig

1994 Plymouth... | Answered on Feb 02, 2018 | 42 views


mass air flow censor

1991 Plymouth... | Answered on Dec 20, 2017 | 96 views


A bad heater core will cause passenger floor wet

1993 Plymouth... | Answered on Sep 26, 2017 | 42 views


5000 to 7500 on conventional oils. 10000 on synthetics. i wouldnt go any higher than that.

1993 Plymouth... | Answered on Sep 26, 2017 | 75 views


Sounds like one of your pulleys is bad. Alternator, water pump, don't know till you find it. You say you have more than one belt-try taking one off at a time, run engine for a couple of minutes and see if squealing goes away. Maybe you can isolate it that way.
If belts are off, you could spin each pulley by hand to see if you could catch the one that is bad. Any little wobble or play in any of the pulleys would be very suspect as the likely bad one.

1991 Plymouth... | Answered on May 11, 2017 | 76 views


check relay in your electrical box on the drivers side under the hood

1994 Plymouth... | Answered on Mar 11, 2017 | 106 views


rear of the engine

1994 Plymouth... | Answered on Mar 11, 2017 | 47 views


Could be either. If you can get it to your favorite auto parts store they can diagnose and recommend replacements. It could also be the signal light system has a short and draining the battery. Easy test is to remove the fuse for that system overnight. or positive supply to that system.

1989 Plymouth... | Answered on Mar 11, 2017 | 41 views


loose connection on the temp sender unit, broken wire to temp sender unit
low coolant level in the system/ air lock

1990 Plymouth... | Answered on Mar 11, 2017 | 30 views


front of the engine see picture below.

2da1ac1.jpg

1992 Plymouth... | Answered on Mar 11, 2017 | 152 views


Probably something wearing out back there.

1994 Plymouth... | Answered on Mar 11, 2017 | 36 views


i had a faulty speedometer unit on mine replaced and all was fine

1994 Plymouth... | Answered on Mar 11, 2017 | 27 views


Buy a shop manual.

1988 Plymouth... | Answered on Oct 14, 2016 | 108 views


There is a door inside your dash that switches from heat to defrost when you operate the dash control, it is not working. Could be as simple as a bad vacuum hose. You are lucky it is on defrost since it is close to winter.

1994 Plymouth... | Answered on Oct 14, 2016 | 47 views


22 years old?

1994 Plymouth... | Answered on Oct 14, 2016 | 25 views


Just remove all the bolts after draining and drop down. Make sure no gasket material is left on the lip

Plymouth... | Answered on Oct 05, 2016 | 34 views

Not finding what you are looking for?
Cars & Trucks Logo

-216 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Plymouth Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...