Plymouth Sundance - Popular Questions, Answers, Tips & Manuals

0helpful
1answer

Where is the fuel pump emergency shut off or relay?

you dont have one
8/2/2021 8:11:22 PM • 1993 Plymouth... • 27 views • 0 helpful votes
0helpful
1answer
0helpful
1answer

Vibration/ shaking at speeds above 90km/h

The problem will be some where between the road wheels and the suspension mounts on the chassis. Here's a check list to try. -Wheel rims. Balanced doesn't mean straight. -Loose wheel bolts. -Brake discs for warping, Pads for wear and calipers for sticky pistons or loose fit -Hubs and bearings for wear. -Ball joints for wear. -Suspension mounts, top and bottom. -Suspension swing arms at both ends. Do this for the front AND the rear of the car. If none of these are the issue you might have to get the drive shafts and transmission checked.
3/3/2018 7:51:03 PM • 1994 Plymouth... • 164 views • 0 helpful votes
0helpful
1answer

91 Plymouth Sundance 2.2 engine. I replaced the fuel pump, fuel pressure regulator and the Automatic shutdown relay that also acts as fuel pump relay...no power getting to fuel pump...any ideas?

there is another fuel pump relay. also check oil sending unit, sometimes they are wired to shut fuel pump down upon low oil pressure.
1/27/2018 3:55:35 AM • 1991 Plymouth... • 264 views • 0 helpful votes
0helpful
1answer

92 Plymouth sundance duster 3.0 v6* engine drops battery power and will sometimes die when shifting from second to neutral and coming to a stop!

check voltage to battery with vehicle running it should be 14.25 volts .minimum 13.25volts. if voltage is not enough then voltage regulator ,and, or alternator is bad. make sure belt is not loose.
2/13/2018 7:22:58 PM • 1992 Plymouth... • 107 views • 0 helpful votes
0helpful
1answer

1998 PLYMOUTH SUNDANCE. RIGHT BLINKER WORKS SOMETIMES BUT STOPS WORKING. I WAS ABLE TO FIDDLE WITH IT AND GET IT TO COME ON AGAIN BUT NOW IT JUST WONT WORK AT ALL. LOOSE WIRE? IM A GIRL AND I DONT WOR

Sounds like a blown globe check the globe on the blinker that is not working it will probably be black or if you have good eyes you may see that the little wires that connect the two little prongs inside the globe are broken. Hard to see so as they are only a couple of dollars best just replace the globe on the one that is not working. To access you may need a Philips head screw driver to take the cover off. Or it may require the globe case may need to be turned from the inside. If you are not shore how to get it of take it to a place like a auto shop they will probably change it for you This is most likely the problem. Let me know if this fixes it. Regards Craig
2/2/2018 5:06:04 AM • 1994 Plymouth... • 65 views • 0 helpful votes
0helpful
1answer

I am losing water/antifreeze somewhere

A bad heater core will cause passenger floor wet
9/26/2017 10:24:03 PM • 1993 Plymouth... • 57 views • 0 helpful votes
0helpful
1answer

Squealing noise

Sounds like one of your pulleys is bad. Alternator, water pump, don't know till you find it. You say you have more than one belt-try taking one off at a time, run engine for a couple of minutes and see if squealing goes away. Maybe you can isolate it that way. If belts are off, you could spin each pulley by hand to see if you could catch the one that is bad. Any little wobble or play in any of the pulleys would be very suspect as the likely bad one.
5/11/2017 4:27:03 AM • 1991 Plymouth... • 111 views • 0 helpful votes
0helpful
1answer

Real wheel hub is bent, can it be replaced or whole thing rplced?

Must be replaced.
4/22/2017 6:30:03 AM • 1993 Plymouth... • 170 views • 0 helpful votes
0helpful
1answer

91 plymouth sundance bogs down

mass air flow censor
3/29/2017 6:06:03 PM • 1991 Plymouth... • 168 views • 0 helpful votes
0helpful
1answer

My 1994 plymouth sundances speedometer stops working when i turn my heater on, what would cause this?

i had a faulty speedometer unit on mine replaced and all was fine
2/23/2017 3:53:12 AM • 1994 Plymouth... • 51 views • 0 helpful votes
0helpful
2answers

What causes temp gage on my 1990 Plymouth Sundance to flucate

loose connection on the temp sender unit, broken wire to temp sender unit low coolant level in the system/ air lock
12/11/2016 1:50:18 AM • 1990 Plymouth... • 53 views • 0 helpful votes
0helpful
1answer

TRYING TO FIGURE OUT WHY MY NOTHING IS COMING OUT OF MY VENTS WHEN I TURN ON MY HEATER, MY DEFROSTER IS THE ONLY THING THAT WORKS.

There is a door inside your dash that switches from heat to defrost when you operate the dash control, it is not working. Could be as simple as a bad vacuum hose. You are lucky it is on defrost since it is close to winter.
10/14/2016 12:11:13 AM • 1994 Plymouth... • 61 views • 0 helpful votes
0helpful
1answer

My car is a 1994 plymouth sundance

22 years old?
10/14/2016 12:12:40 AM • 1994 Plymouth... • 45 views • 0 helpful votes
0helpful
1answer

Replacing an oil pan on a Plymouth sundance

Just remove all the bolts after draining and drop down. Make sure no gasket material is left on the lip
10/4/2016 11:04:58 PM • Plymouth... • 45 views • 0 helpful votes
0helpful
1answer

I found the fuse box on the left lower side on the driver's side. Which fuse is it? Or are there other fuse locations?

Fuse for what exactly?, normally there are two fuse box locations, one on the inside like you mention above, the other would be under the hood. It depends on which fuse or relay you are looking for and wish to replace!
9/20/2015 9:47:12 PM • 1989 Plymouth... • 214 views • 0 helpful votes
0helpful
1answer

New fuel pump will pump air out but not gas?

Is it hooked up right ! Have seen wires reversed causing same problem !
9/7/2015 6:38:08 PM • 1994 Plymouth... • 178 views • 0 helpful votes
0helpful
1answer

How to replace a fuel pump.

You will have to drain the gas tank (remove battery connection first). There will be a couple of straps or brackets holding the tank in place. Remove those and drop the tank. On the top you will see the fuel pump fastened into the tank on the top side. Remove that, replace with new one and put it back together. You may have to reset the fuel shut off to get it running again.
6/18/2015 1:46:07 AM • 1993 Plymouth... • 73 views • 0 helpful votes
0helpful
2answers

Hi. My car was running well, until I noticed the signal lights failed to work. After I parked it and tried to restart the car, it didn't start. I got boosted..next day no start. Battery or alternator?

Could be either. If you can get it to your favorite auto parts store they can diagnose and recommend replacements. It could also be the signal light system has a short and draining the battery. Easy test is to remove the fuse for that system overnight. or positive supply to that system.
6/14/2015 5:59:09 PM • 1989 Plymouth... • 51 views • 0 helpful votes
Not finding what you are looking for?
Cars & Trucks Logo

489 questions posted

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...