20 Most Recent 2007 Chevrolet Chevrolet Uplander Questions & Answers

Ricky, Went to rockauto and found the actuator..it says it's behind the glove box. Best to you.

Question edited to add Maker. Question move to year make model category. For strange error messages like that you need an auto-electrician with a pro grade scan tool computer to find out which is the modules and sensors has failed and is reporting wrongly. A standard code reader isn't bi-directional and can't do this. If the vehicle is driving fine, you can just ignore it. https://www.google.com/search?q=auto+electrician+near+me ..

the video i watched said you need a 34mm deep socket.

About 23,400 results (0.81 seconds) Search Results

Plug in glove box?? ' VW TDI forum, Audi, Porsche, and Chevy Cruze ...

www.myturbodiesel.com/threads/plug-in-glove-box.16414/
Oct 22, 2012 - 17 posts - ‎8 authors Asked vw and they said it is a iPod/mp3 player port. Plugged in ... 06 jetta tdi and there is a plug in my glove box that looks like a headphone jack. Asked vw ... Joined: May 23, 2007 ... Try pressing CD twice to go to aux input .... box. It is locateded on the farright side where the light is on most mk5 models.Missing: uplander

Head unit "Aux" input information... - Suzuki Forums: Suzuki Forum ...

www.suzuki-forums.com/.../14338-head-unit-aux-input-information.htm...
Jun 28, 2006 - 10 posts - ‎5 authors This cable gives you an AUX input into the stereo, so you can listen to ... There is a plastic damper attached to the right side of the glove box (a ...Missing: uplander

[PDF]Get To Know Guide - Chevrolet Owner Center

https://my.chevrolet.com/.../2007/chevrolet/uplander/2007_che...
ChevroletR. Glove Box. Getting to Know Your. Uplander. 2. See Section 3 of your Owner Manual. Instrument Panel. DRIVER INFORMATION. Uplander 2007 A 7/24/06 ...

Only Driver's side speakers working when using the aux input on

Temperature control sensor ? You'll need to do a little better job of explaining what you mean > engine coolant temp sensor ? What is the problem you are having ? Temp. gauge not working etc...

Just pull up evenly, it will pop off.

YOu may need a special belt tensioner tool to reach the tensioner easily. draw a map of the belt routing if there is not one on the covers, so you don't put the new belt on wrong. it happens. I don't take chances. other than that just do it. good luck

You may have a serious problem with your transmission. Take it to a transmission repair centre urgently.

Replace the turn signal switch. All exterior lights run threw it except the high mount brake light.

is there a drivers over ride switch to lock out the rear windows . is it the switch on the rear door that was replaced ? can you check for an over ride lock out switch on drivers controls .

Is the vehicles check engine light on steady or flashing ? Sounds like an engine misfire .

Could be the exhaust system hitting the frame or body of vehicle when you hit a bump. There should be some wear marks where the pipe is hitting.

Remove old filter watch it it full of oil after remove the bolt holding the adaptor clean it in new seal reinstall

You will have to look in the manual as to where it is but you need to reset the fuel shut off switch

Sounds like the lock cylinder has failed. Have you tried a spare key, and does the key still fit the door lock ?

Have it tow to the repair shop !!!!!!

http://www.youtube.com/watch?v=kXP7s-gCOkg

the throttle position sensor will be located on the throttle body. If you follow the air induction hose that comes from the air filter housing to the engine it will be there where the hose clamps down

does the motor turn over when u turn the key