20 Most Recent
2008 Toyota Tacoma - Page 8 Questions & Answers
2008 toyota tacoma whistling noise
I don't know how loud the noise is, but its weird that you mention 50 mph. At that speed or above you are keep a constant rpm level. I say this because it might just be your air box loose and the sound of the intake air is making it. A 2008 truck should not have any major problem. Sometimes an alternator will sing or whine but never heard anyone say something is whistling. One other thing is sometimes for some reason ive heard a noise like that coming from the speakers of my car that goes up and down with the speed of the motor, but that was when I was tinkering with speakers and sub outs and amps. Thats all I can think of.
4*4 not eagaging light keep flashing
Wat i did was to install a reset button on the 4wd computer and each time it flash . i put it into neutral and press the button . For example If i mistakinly press the 4wd while in park the indictor will flash.I then have to put it in nuutrat press the button and it will stop flash and either select or come off from flashing.
1999 Toyota Tacoma 2.4L sputtering
Mixture too rich. Make sure none of the injectors are leaking (any o-rings). Disconnect the battery to try and clear the ecu- sometimes it stores data on how the engine is running to adjust the fuel/air mixture. It may need to "reset" and start from scratch.
2014 Toyota Tacoma X-Cab: How can I remove the flip up headrests in the small x-cab rear sear?
The rear headrests are not a pull out design. They are bolted in place. You will need to remove the backrest panel to access the 4 bolts fastening each one to the rear bulkhead.
I think the panels are only held in place with 'push in' clips like door card panels. *Carefully* lever the sides of the panel towards you until you feel them pop loose. there is a good chance you will break some of this clips but they are cheap to buy. The panel unclips then slides UP and off.
If you are removing both headrests it might be easier to remove the entire panel to unbolt both headrests. This isn't a difficult job, it's just a pain in the tailbone to do and like most jobs on a vehicles it'll probably cost you the skin of at least one knuckle.
My avital alarm does not
With your drivers door wide open and no key in the ignition, press the remote control buttons.....lock-unlock-lock....within one second and the alarm will come out of valet mode, which it's currently in right now.
Not finding what you are looking for?