Top 20 2006 Toyota Corolla Questions & Answers

The transmission has stopped working in your car and has to be replaced.

car repairs

Sure I will tell you how to get away from those annoying beeps I know what you're talking about it's very easy what you want to do is get on YouTube and type in Toyota Camry how to disable the beeps on my keyless entry and once you do that you can just press it and your doors will lock without the annoying beat you can also check with the dealer and they will teach you for free how to do that I hope my answer has helped

At www.reliable-store.com get complete guide on whether to repair or not, service it, and how to repair etc, along with wiring diagrams, electrical diagrams, torque specs, error codes, everything.

If you check in your owner's manual sometimes there are controls in-built to do this it depends on the spec of the vehicle if not I would get a auto electrician to sort it out you could make things worse and loose all instruments in the dashboard I hope this helps

Does it run for a full minute or start then shut off within a few seconds? If the latter, then it sounds like the anti-theft system has kicked in and needs to be reset.

get a test light and check your fuses also check for rusty ground wires

Sounds like possible Idle Speed Control (ISC) issue. Start by having computer codes read by dealer or other facility.

Check all the fuses located in the lower panel of the dash board on the passenger side with a test light 12V or multimeter. Ground one end of the tester to good known ground and the tip to each side of every fuse one by one. If the tester light glows that particular fuse under test is OK. If not, that fuse is burnt. Replace it with the same rating of new fuse and you are good to go.

check the cable adjustment for codes p 0121 before spending money on position sensors the pressure (TFP) will fix the transmission problem P0607 is the control module however before getting a replacement ECM check for wires and connections check for moisture and/or dirty pins in the connections I would go for good replacement parts from a wreckers/junk yard rather than new parts to save money or have an accredited service shop check the components first

Blown fuse

Sometime you can go to the dealer were the car was brought and they might have a spear ??, or you can go and get one programmed to your car. Good luck. Hope this help. Any Toyota dear can help!

You have fuel leakage on the pressurized/engine side of the fuel delivery line or filter at engine has a bad o-ring from being over tightened. Check all with engine running. And you should see a bit of fuel on the ground at the leak point.

Check the door rubber seal for flat spots or maybe something stuck to it causing water to get past it.

The AC condenser is not able to drain the condensate and it is trapped. Locate the condensate tube and clean it out.

Do the following: - Clean the battery terminals with Luke-warm water, dry them with dry cloth and fix them firmly. - Check the battery to engine ground wire. Remove the engine side ground wire and clean it with sand paper to provide a good contact. Replace this wire with a thick one to hold the current during starting. Also battery to starter wire should be thick enough to hold the current during starting. - Check the alternator output and the battery health.

Automatic idle control module and the valve it controls on the engine need attention. Sometimes a simple cleaning of the valve is all that's needed.

The switch that controls it may be dirty internally. Try sliding the switch that chooses left or right a little more aggressively and press the buttons a little harder.

I would need to feel this to diagnose it. Most likely you have lost the engine idle speed learned information and this means you must drive it for a week or so for the idle to relearn your habits.

Fuse box under hood