20 Most Recent
2003 Toyota Camry Solara - Page 7 Questions & Answers
HOW DO I RE ATTACH
The wire that has 12 volts to it goes to the center terminal of the lighter/power outlet, the ground wire goes to the outside sheet metal retainer ring..
My car has engine light
- In the vast majority of cases, simply cleaning the MAF sensor does the trick. Consult your service manual for it's location if you need help. I find it's best to take it off and spray it with electronics cleaner or brake cleaner. Make sure you are careful not to damage the MAF sensor, and make sure it's dry before reinstalling
- Inspect all vacuum and PCV hoses, replace if necessary
- Check for a dirty fuel filter and proper fuel pressure
- In the vast majority of cases, simply cleaning the MAF sensor does the trick. Consult your service manual for it's location if you need help. I find it's best to take it off and spray it with electronics cleaner or brake cleaner. Make sure you are careful not to damage the MAF sensor, and make sure it's dry before reinstalling
- Inspect all vacuum and PCV hoses, replace if necessary
- Check for a dirty fuel filter and proper fuel pressure
- good luck.
How hard is it to
Seat belts are pretty simple. The airbags just be careful the one in the steering wheel is pretty easy but the one on the passengers side can be a pain.
It does not start or
If the engine turns over easily , check the timing belt. Let me know what happened when the car died and We might figure it out, Also the year, make, model, engine size
Where can i get a
you will need to get a Japanese (english) manual.OR find a manual for the equivalent (different name)car (whats a "coaster" ,not available in Europe/Russia.........
Wanting to remove backseat bottom
Put your fingres between seat and body and pull upwards. Harder, thats it, see its out. To put it back use the palm of you hand once the lugs are centred.
Car runs then dies toyota
Problem may be idle control. In throttle body, butterfly valve can get gummed up and stick causing motor to start but then die. Remove air passageway from front of throttle body and spray intake cleaner or chemtool B12 inside while holding throttle open. This should clean up gummy residue and allow idle control to work properly. This works for us.
I have a 2001 Toyota
Happens all the time on ours. You need to take two flat blade screwdrivers and work out the fold in the
seal belt at the top and push the belt back into the slot and all will be well. It takes a few minutes of
working with it and perhaps a few choice words but
if you will keep at it and undo the fold in the belt, it will go back in. To avoid this in the future try to get in the habit of holding the buckle straight out in front of you as the belt retracts when you unfasten your seatbelt.
What cause a car make the noise on the wheels when driving.
1- It could be wheel bearing worn down. You can check this by jack up each wheel, and juggling in rotation to see a circular gap play.
2- It could be wheel nuts loosed to make noise. Remember after replacing tires, any shop always tells you to bring car back after driving for a certain distance to make sure these nuts are not loosing.
I recently bought a used
You need to look under the firewall and that usually on the windshield side look under the exact location of the sprayer if you can not see an opening to slid the tub then you need to make a small cut under each one and slide the tube back way that way you insert in the new cut the end first to wards the windshield then connect the other end to the sprayer and the th side you installed first take it to the other end and connected…it is just a matter of looking for the small opening under the firewall.
....let me know if that work for you and please do not forget to rate my service so I am able to continue providing same...god bless
1 thump not related
2 thump related but no recommendation
3 thumps related worked some issues
4 thumps related worked all issues and satisfied
2004 Toyota Sienna. Driver side sliding door problem.
It is not clear whether your key fob continues to work for the passenger side door. If it does not, you should replace the battery in the fob. Such batteries are available at Wal-Mart among the batteries. If the sliding door on the driver's side makes a noise but fails to open when you use the fob, the latch motor maiy have failed. If the cable in the side door has frayed and snapped, this would explain why you can manually open and close the door but the electronics won't move the door. And if while trying to close it manually, the door fails to latch properly, this is why you get an alarm. If the latch motor, cables, or any other components are malfunctioning, it could lead to the door not closing securely, triggering the alarm. Check your latch mechanism and cables. If you can determine the malfunctioning part and replace it yourself, that is cheaper than going through the dealer. Here is a service manual:
https://www.manualslib.com/manual/1061909/Toyota-Sienna-2004.html
What To Do When Your Sienna's Side Door Won't Open Or Close ' Toyota Parts Center (olathetoyota.com)
What is the engine torque settings for k3 toyota Avanza
Exactly which nuts and bolts do you need the torque settings for? Not all fasteners on an engine use the same torque setting. For example, a valve cover bolt needs a low torque setting where a cylinder head bolt torque setting will be much much higher.
If your rebuilding an engine it is usually a good idea to buy a good quality workshop repair manual which will have all the settings you need.
Not finding what you are looking for?