20 Most Recent
2002 Toyota Corolla - Page 10 Questions & Answers
I have a toyota nze it has aproblem of showing
Hi there!
The brake light is always an indication of low fluid level or low pressure in the fluid system. The ABS light comes on when a problem detected with one of the 4 sensors or wires that connect the sensors to PCM in your vehicle. So what you can do is check the fluid level and about the ABS you will need to scan it to see whats the code that was stored. Good luck
My headlight went out after
if you touched the glass on the bulb with your fingers or hand in any way then the oil from skin would make the bulb burn out after a short period of time also some of these aftermarket bulbs are junk. i do not think in any way that you have any fuse or wiring problems.
Hi, the radio on my
look down by the drivers side kick panel, under the dash on the drivers side,
I can't find the
The fuel filter for a Toyota Corolla from 2002 and later is inside the fuel tank there is no external fuel filter. It's generally assumed that these filters don't need to be replaced unkless the fuel pump is replaced which is also inside the fuel tank.
How do I remove and
specting you have your new door handle on hand, star by removing philips screw, look at your new door hanle and it has tabs or hooks(some are forward others to the back) well now you know to what direction pull/push the handle to unhook, pull a litle on it until you see a steel rod hooked to handle, take a neddle nose chanel locks and cramped, use a small screw driver to remove clip holding rod, now intall new handle back tracking.
good luck
I have a 2004 Toyota
Hello, take your door trim off and take a good look at the wiring which goes to your electric motor, see if it has been rubbing on any parts, unplug and plug in any connections and see if there is dirt/dust in the plugs, it sound like a poor contact in your wiring. Do not go buying anything until you have pin pointed the problem. If you or a friend is handy with electrics you can also test the motor by using a 12V battery straight onto the motor, bypassing all switches and wiring to see if the motor is ok or not. Start by removing the door trim and leave it off until fixed.
Not finding what you are looking for?